102386 Kurzbedienungsanleitung FOCX32 ... - Elcon Systemtechnik

FOCX32
Adapter connector
Figure 7: Cable fitting
Installation of the cable adapters
Figure 8: Mounting the cable fitting
ATTENTION: To avoid damage to the ELCONnect
coax FOCX32, cut the inner conductor to
14 mm ± 1 mm length.
1.) Screw-in the cable fitting
ATTENTION: Upon screwing-in, make
sure that the rubber seal is placed correctly,
to provide for the required degree of
protection.
2.) Tighten the locking screw on the circuit
board
ATTENTION: Before the screw is tightened,
make sure that the inner conductor
would not touch any components, since
this may cause damage to the device. If
necessary, shorten the inner conductor
(figure 7).
2.6 Mounting of the SC/PC-Connector on the optical fiber and connection of the fiber
cable
The FOCX32 accommodates inside a TX-1310/RX-1550 nm single-mode bidirectional (single-fiber)
transceiver. Its design is the same as that of a 2×5 SC simplex connector with
3.3 V-supply voltage and 17 dB margin as figure for the admissible subdued light.
The specification for the transmission characteristics complies with the IEEE802.3ah,
100Base-BX10-U/ITU-T G.985 / Fast Ethernet.
The SC-plug connector (IEC 874-19) represents a generation of connectors, which can be
recommended for any types of new installations. The Subscription Channel (SC) Connector is
known for its audible „click“ sound upon locking and unlocking the plug-in connection. The
special mechanical bayonet fitting is protected against accidental disengagement. The SC/PC-
Connector contains a Physical Contact (PC) with a curved and polished Ferrule end, so that
the return loss is increased.
There are several options how to mount the SC/PC-Connector in the field. They differ by their
quality characteristics and can be applied depending on the required admissible insertion loss:
Version: 2009/01/29 33