Pan/Tilt Head with Multiple Protocol Interface VPT-601 ... - Belcom

7.12 To call a preset scene *
1. Call or hold the pertinent camera on the monitor.
2. Enter the desired scene number (1-64) on the keyboard.
3. Press „PRESET” on the keyboard. *
7.13 Autopan operation *
Using the VPT-601, it is possible to carry out autopan operations. In this, shots 63 and 64 are used as change-over points for this mode of operation.
a) To configure autopan
1. Position the camera to the desired start position.
2. Enter 63, then press „PRESET” for 2 sec. on the keyboard.
3. Position the camera to the desired stop position.
4. Enter 64, then press „PRESET” for 2 sec. on the keyboard.
b) To start autopan operation
Press the appropriate button on the keyboard. The receiver uses the positions stored in shots 63 and 64 to determine the autopan operation.
NOTE: Preset shots 63 and 64 can be used both as autopan end stops and as normal preset scenes.
c) To stop autopan operation
The camera continuous panning until manually stopped by the operator, either by calling a preset shot or by using the keyboard pan functions (joystick or direction
buttons).
* The SET and CALL controls may differ on certain keyboards;
refer to the applicable keyboard manual for specific keyboard preset actions.
8. Command format (Videor protocol)
The date format is made up of 8 data bits, no parity bit and a stop bit. A baud rate between 300 Bd and 19,200 Bd can be selected (further details upon request)
39