Dynaudio SUB 300/500 - Studio 22
Dynaudio SUB 300/500 - Studio 22
Dynaudio SUB 300/500 - Studio 22
Sie wollen auch ein ePaper? Erhöhen Sie die Reichweite Ihrer Titel.
YUMPU macht aus Druck-PDFs automatisch weboptimierte ePaper, die Google liebt.
Operation<br />
Operation<br />
Operating the subwoofer<br />
1.<br />
2.<br />
3.<br />
Fitting the remote control battery<br />
Before the DSC 1 remote control can be used, it needs to be fitted with the battery cell<br />
that comes separately packed with the remote control.<br />
To replace and insert a battery:<br />
1. Release the battery tray by pushing its locking tab on the back of the remote<br />
sideways with your nail and at the same time slide the tray out of the remote<br />
control battery compartment.<br />
2. Remove the exhausted battery and dispose of properly. Insert a new battery in the<br />
battery tray: observe correct polarity (both battery and tray are marked with a “+”).<br />
3. Slide the battery tray into the battery compartment until the locking tab clicks into<br />
place. Make sure it is inserted the correct way up, the tray will slide into place<br />
easily, do not use force.<br />
Note<br />
• The battery will last a considerable time, depending on frequency of use. When you<br />
notice that the subwoofer doesn't always respond or only from a very close range<br />
to commands from the remote control, it is likely the battery is exhausted and will<br />
need replacing.<br />
• Use only CR2025 button cell batteries to replace the original battery with. These<br />
are readily available from most electrical stores.<br />
• Do not leave the remote control in high temperature environments (such as in<br />
direct sunlight) as it can possibly result in deformation of the remote's case.<br />
<strong>Dynaudio</strong> <strong>SUB</strong> <strong>300</strong>/<strong>500</strong> 9