Dynaudio SUB 300/500 - Studio 22

Operation
MANUAL mode for On/Standby
If you prefer the subwoofer to stay switched on or to Standby all the time you can
override the AUTOMATIC mode completely. The MANUAL mode LED indicates to
which state the subwoofer is set: in MANUAL mode the LED is green. Note that in
Standby the LED is always off, regardless if it is in AUTOMATIC or MANUAL mode.
LEVEL
POWER
To switch to permanent On
Press and hold the green I button for 2 seconds.
The MANUAL mode LED will light up green. If the subwoofer was already switched
on, it will remain on; if it was set to Standby, it will switch to On.
LEVEL
POWER
To switch to permanent Standby
Press and hold the red O button for 2 seconds.
If the subwoofer was already switched to Standby, it will remain in Standby; if it
was switched on, it will switch to Standby.
The subwoofer can be switched from Standby either manually or automatically. The
subwoofer is factory set at AUTOMATIC mode, as this will be the most convenient
setting in most cases.
LEVEL
POWER
Back to AUTOMATIC mode:
Press either the I or O button briefly.
Regardless if the subwoofer is switched on or in Standby mode, the subwoofer will
switch back to AUTOMATIC mode again. If the Manual mode LED was lit, it will
extinguish.
Note
• Unlike all other functions on the remote control, the POWER buttons remain active
when the subwoofer is set to Slave mode.
• When powering up, the subwoofer always reverts to the same settings as when it
was switched off. Even if mains power is removed completely for a prolonged
period of time, the last settings will be retained.
Dynaudio SUB 300/500 11