und Bedienungsanleitung für den Garagentorantrieb ... - Rademacher

Alarm settingGBIf the alarm is switched on, the door operatorbeeps if the door is open for longer than 10minutes. The door operator beeps for 30seconds every 10 minutes.To end the beeping:Press the door control button to fully close the door.1. Press „+“ (press severaltimes if necessary) until„6“ is displayed.2. Press „P“,the display is „0“.(0 = off = factory setting)3. Press „+“,the display is „1“ .(1 = on = the alarm setting isswitched on)4. Press „P“ in order tostore the alarm setting.5. Conclude programming(refer to page 53, method 2)orproceed with next setting.Automatic closing time settingNOTEBefore the door closes automatically, the door operatorbeeps for 20 seconds. At the same time the light flashes.When the door starts closing, the light shines durably and itbeeps permanently.After the door has closed, the door operator ends thebeeping and the light remains on for a further 3 minutes.1. Press „+“ (press severaltimes if necessary) until„7“ is displayed.2. Press „P“,the display is „0“.(0 = off = factory setting)3. Press „+“,the display is „1“.(1 = on = automatic closingtime = 30 seconds)51