JB N20 Stage 1 Install Guide

ePAPER READ

DOWNLOAD ePAPER

burgertuning.com

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

START NOW

Once the cover is loose you will be able to hold it up to access the solenoid connector (#1) aft of the oil

cap as shown below (green arrow). If this connector is not present on your vehicle, leave this

connector disconnected on the JB N20 Stage 1 harness. It will remain unused.

Below is a photo of the connector with the engine cover removed for illustrative purposes.

BMS N54 / N55 Oil Catch Can - BurgerTuning.com

the JB3 pin out install - Burger Motorsports

Power Box 325i / 328i / 528i Installation Guide - Burger Motorsports

Juice Box Stage 4 PnP - Burger Motorsports

JB N55 Stage 1 and Stage 2 Install Guide

Starting near the oil cap, you will be locating the first connector for the solenoid connection. Firmly pull up on the engine cover to release it from its retainers.

Once the cover is loose you will be able to hold it up to access the solenoid connector (#1) aft of the oil cap as shown below (green arrow). If this connector is not present on your vehicle, leave this connector disconnected on the JB N20 Stage 1 harness. It will remain unused. Below is a photo of the connector with the engine cover removed for illustrative purposes.

Page 1: JB N20 Stage 1 Install Guide Last U
Page 5 and 6: Now route the wire harness over the
Page 7 and 8: Now connect the large connector on
Page 9 and 10: Push lightly on the release clip to
Page 11 and 12: Pull the weather seal forward as sh
Page 13 and 14: Route the JB N20 Stage 1 harness an

JB N20 Stage 1 Install Guide

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?