JB N20 Stage 1 Install Guide
JB N20 Stage 1 Install Guide
JB N20 Stage 1 Install Guide
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Push lightly on the release clip to release the connector from the sensor. Do not pull directly on the<br />
wires. Be careful to ensure that, once released, the factory connector does not fall backwards. Hold<br />
onto the connector until you have connected it to the last, multi-colored wire connector pair of the <strong>JB</strong><br />
<strong>N20</strong> <strong>Stage</strong> 1 Harness as shown. Please note the orientation of the clips in this picture. Connectors #3<br />
and #4 are both shown in this photo.<br />
Now locate the plastic cover over the brake booster as shown. Note the small ring near the side of the<br />
vehicle.
Change language