JB N20 Stage 1 Install Guide

More documents

Recommendations

Info

Push down on the metal retaining clip as shown and slide the connector back. Do not pull directly on the wires, make sure to pull on the connector. Lay the JB N20 Stage 1 harness over the engine and locate the connector pair with blue wires. Plug the female connector on the JB N20 Stage 1 harness over the factory connection as shown, making sure that the retaining clip clicks into place. Then, plug the factory harness connection you removed in the last step onto the male connector on the JB N20 Stage 1 harness, making sure that the retaining clip clicks into place.
Now route the wire harness over the back of the engine cover area as shown below. Next, locate the MAF connector plug (#2) near the factory airbox at the front of the engine.
Page 1 and 2: JB N20 Stage 1 Install Guide Last U
Page 3: Once the cover is loose you will be
Page 7 and 8: Now connect the large connector on
Page 9 and 10: Push lightly on the release clip to
Page 11 and 12: Pull the weather seal forward as sh
Page 13 and 14: Route the JB N20 Stage 1 harness an

JB N20 Stage 1 Install Guide

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?