FLEX I/O EtherNet/IP Adapter Module User Manual, 1794-UM006A ...

More documents

Recommendations

Info

C-2 Configuring the RSLinx Ethernet Communication Driver Configuring the AB_ETH Driver Publication 1794-UM006A-EN-P - July 2001 To configure the AB-ETH Ethernet communication driver perform the following steps: 1. Start RSLinx. 2. From the Communications menu, select Configure Drivers. 3. Click on the arrow to the right of the Available Driver Types box. The Available Driver Types list will appear. 4. Select Ethernet Devices and click on Add/New. You will be prompted to name the driver. 5. Select the default driver name (e.g., AB_ETH-1) or type in your own name and click on OK.
Configuring the RSLinx Ethernet Communication Driver C-3 The Configure driver window will appear with the Station Mapping page open. 6. Click on Add New and enter the IP address or Host Name of your Ethernet device (e.g., 130.130.130.2, “Pump1”, etc.). 7. Repeat step 6 for each additional Ethernet device you need to access. 8. When you are done entering the IP addresses, click on Apply. Then click on OK to close the Configure driver window. Publication 1794-UM006A-EN-P - July 2001
Page 1 and 2:
FLEX I/O EtherNet/IP Adapter Module
Page 3 and 4:
Throughout this manual we use these
Page 5:
Rockwell Automation Support Rockwel
Page 8 and 9:
P-2 About This User Manual How To U
Page 10 and 11:
P-4 About This User Manual Where to
Page 12 and 13:
P-6 About This User Manual Publicat
Page 14 and 15:
P-8 About This User Manual Publicat
Page 16 and 17:
Table of Contents ii Using Analog I
Page 18 and 19:
1-2 About the 1794-AENT Adapter Har
Page 20 and 21:
1-4 About the 1794-AENT Adapter Sup
Page 22 and 23:
1-6 About the 1794-AENT Adapter Pub
Page 24 and 25:
2-2 Installing the 1794-AENT Adapte
Page 26 and 27:
Page 28 and 29:
Page 30 and 31:
3-2 Configuring the 1794-AENT Adapt
Page 32 and 33: 3-4 Configuring the 1794-AENT Adapt
Page 38 and 39: 3-10 Configuring the 1794-AENT Adap
Page 44 and 45: 4-2 Using Rack Optimized Discrete I
Page 52 and 53: 4-10 Using Rack Optimized Discrete
Page 60 and 61: 5-2 Using Analog I/O with Direct Co
Page 68 and 69: 5-10 Using Analog I/O with Direct C
Page 74 and 75: A-2 LED Status Indicators Publicati
Page 76 and 77: B-2 1794-AENT Adapter Web Pages Pub
Page 84 and 85: C-4 Configuring the RSLinx Ethernet
Page 86 and 87: 2 Index N network status indicator
Page 88: Other Comments PLEASE FOLD HERE BUS
show all

FLEX I/O EtherNet/IP Adapter Module User Manual, 1794-UM006A ...

Create successful ePaper yourself

Delete template?

Save as template?