SolarEdge Configuration Tool Software Guide - Solon

More documents

Recommendations

Info

30 Configuring an Inverter SolarEdge Configuration Tool Software Guide Parameter Description country’s local certification requirements. However, if you get proper authorization from your local grid and code bodies, these parameters can be changed to accommodate different grid parameters. After getting this authorization, contact SolarEdge for instructions on how to change these parameters. [Apply] Click this button to upload the new Regional parameters to the Inverter. After the Configuration Tool finishes uploading the parameters to the Inverter, the Inverter automatically shuts down and restarts. Table 17 shows the DSP1 parameters and their meanings. Note that these parameters have a viewing access level and change access level. Monitoring is the lowest level access. Table 17: DSP1 Parameter Definitions Parameter Meaning Write Access INVGRID_VOUT_MAX Maximum Grid Voltage – transient (V) Viewing Technician Monitoring INVGRID_VOUT_MIN Minimum Grid Voltage (V) Technician Monitoring INVGRID_VOUT_MAX2 Maximum Grid Voltage – steady state (V) Technician Monitoring INVGRID_F_GRID_MAX Maximum Grid Frequency (Hz) Technician Monitoring INVGRID_ F_GRID_MIN Minimum Grid Frequency (Hz) Technician Monitoring Optimizers Data The Optimizers Data tab comprises two sections: Connected Optimizers Live Parameters – a table which displays information about the Optimizers that are connected to the selected Inverter Data Control – buttons for performing operations on Optimizer Records, Optimizer Data, and Telemetry Control
Figure 14: Optimizers Data Tab Configuring an Inverter SolarEdge Configuration Tool Software Guide The Inverter automatically identifies the serial numbers of the Optimizers connected to it, and lists them and the other Optimizer information, in the Connected Optimizers Live Parameters table. The table is refreshed periodically, thus displaying the latest statuses of the Optimizers connected to the Inverter(s). Table 18 describes the parameters of the Optimizers. Table 18: Connected Optimizers Live Parameters Parameter Description # Specifies a sequential number of the rows in this window ID Specifies the unique identifier of the Optimizer VIn [v] Specifies the DC input voltage to the Optimizer, in Volts VOut [v] Specifies the DC output voltage from the Optimizer, in Volts IIn [A] Specifies the input current to the Optimizer, in Amperes Version Specifies the software version of the Optimizer. Time Specifies the last time that the telemetry of the data was received; this indicates the time of the data 31
Page 1 and 2: Version 2.0
Page 3 and 4: Important Notice Copyright © 2011
Page 5 and 6: List of Figures SolarEdge Configura
Page 7 and 8: Introduction SolarEdge Configuratio
Page 9 and 10: NOTE: Introduction SolarEdge Config
Page 11 and 12: Introduction SolarEdge Configuratio
Page 13 and 14: Tab Sub-Tab Description Settings Op
Page 15 and 16: Parameter Description Introduction
Page 17 and 18: Configuring an Inverter SolarEdge C
Page 19 and 20: Configuring an Inverter SolarEdge C
Page 21 and 22: Setting the RS485 Parameters Config
Page 23 and 24: LAN Status Configuring an Inverter
Page 25 and 26: Table 11: Server Connection Status
Page 27 and 28: Parameter Description Configuring a
Page 29: Regional Settings Configuring an In
Page 33 and 34: Adding an Optimizer Configuring an
Page 35 and 36: Miscellaneous Configuring an Invert
Page 37 and 38: Setting Up Multiple Inverters Solar
Page 39 and 40: Setting Up Multiple Inverters Solar
Page 41 and 42: Verifying the RS-232 COM Port Solar

SolarEdge Configuration Tool Software Guide - Solon

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?