S 850-0 EN Operating Instructions Siedle Scope

Getting started
Registering additional cordless
handsets at the base station
Switching the cordless handset
on and off
During the switching on process, a
progress bar appears on the display.
14:34
Monday 21/03/2011
Light Door call
The following display appears during
the registration process:
Searching base
Please wait
After selecting the base, the following
display appears:
Registering handset
Please wait
• As soon as the base station has
been found, confirm the located
base with the left-hand display
button OK.
The cordless handset is now in the
ready status.
After successful registration, the
base station is locked again for new
registrations. This is indicated by a
continuous green LED light.
• To register additional cordless
handsets, disconnect the base station
from the mains power again
and proceed as described above.
Note
The additionally registered cordless
handsets are synchronized to
the correct date and time and the
same intercom settings as cordless
handset 1.
Procedure:
• In order to switch on the handset,
press the red End call button for
around 1 second.
• The handset automatically activates
the power save mode if it is
in the idle status for more than 2
minutes.
• The display switches off.
• A hibernating handset switches
back on automatically as soon as it is
placed in the charging cradle.
• The display terminates the power
saving mode automatically after
around 1 second as soon as it is
removed from the charging cradle.
7