Getting Started with Your 2700 Series Instrument

More documents

Recommendations

Info

Digital Analyzer Chapter 6: Specifications Output to Input Delay Measures propagation from the rear panel AES/ EBU Reference Output to the input. Range –12.7 to +115.1 UI [–10% to +90% of frame] in seconds, 60 ns resolution. Signal Confidence Displayed for total signal (both channels combined) Receiver Lock Displayed for total signal (both channels combined). Coding Error Displayed for total signal (both channels combined). Digital Interface Analyzer <strong>with</strong> “INTERVU” DSP program The Digital Interface Analyzer (Intervu) operates in conjunction <strong>with</strong> an 8-bit A/D converter clocked at 80.0 MHz. The analyzer can display the interface signal in time or frequency domain, as an eye pattern, or probability graphs of amplitude or pulse width. The Digital Interface Analyzer can also demodulate the jitter signal and display it in time or frequency domain or as a histogram. The jitter signal or the data on the interface may be reproduced through the monitor loudspeaker. AES/EBU Input Voltage Balanced 0 Vpp–10.00 Vpp, (10% + 50 mV). Unbalanced 0 Vpp–2.5 Vpp, (8% + 12 mV). Jitter Amplitude 0 UI–5 UI pk, (5% + 0.015 UI). Residual Jitter 0.01 UI (50 Hz–1 MHz BW). Spurious Jitter Products 0.001 UI, or –60 dB below jitter signal. Common Mode Amplitude 0 Vpp–20.00 Vpp, (30% + 50 mV), 20 kHz–1 MHz. Jitter Probability Display 256 bins, auto-ranging. Input Probability Display 256 bins, auto-ranging. Bit Width Probability Display 32768 bins. Risetime Typically 17 ns–20 ns. Acquisition time / memory 19.66 ms / 1,572,864 samples. Embedded Audio Measurements With “ANALYZER” DSP program Wideband Level/Amplitude Range –120 dBFS to 0 dBFS (usable to –140 dBFS). Frequency Range 10 Hz to 45.8% of Sample Rate, [10 Hz–20.2 kHz at 44.1 ks/s], [10 Hz–22.0 kHz at 48 ks/s], [10 Hz–44.0 kHz at 96 ks/s]. Accuracy 0.01 dB. Flatness 0.01 dB, 15 Hz–22 kHz (
Chapter 6: Specifications Digital Analyzer High pass Filters
Page 2 and 3:
Getting Started with Your 2700 Seri
Page 4 and 5:
Contents Safety Information . . . .
Page 6 and 7:
Source Range, Steps, and Spacing .
Page 8 and 9:
Safety Information Do NOT service o
Page 10 and 11:
Chapter 1 General Information Figur
Page 12 and 13:
About This Manual Chapter 1: Genera
Page 14 and 15:
Chapter 2 Installation and Setup 27
Page 16 and 17:
Setting Up the Hardware Chapter 2:
Page 18 and 19:
Setting Up the Hardware Chapter 2:
Page 20 and 21:
Connecting the Instrument to Your P
Page 22 and 23:
Page 24 and 25:
Page 26 and 27:
Chapter 3 Hardware Overview The 270
Page 28 and 29:
The 2700 Series Rear Panel Chapter
Page 30 and 31:
Chapter 4 2700 Series Control Softw
Page 32 and 33:
The 2700 series panels Chapter 4: 2
Page 34 and 35:
The 2700 series menus Chapter 4: 27
Page 36 and 37:
Page 38 and 39:
Page 40 and 41: The 2700 series menus Chapter 4: 27
Page 42 and 43: Figure 16. 2700 series workspace, N
Page 44 and 45: The Analog Signal Path Chapter 5: Q
Page 46 and 47: The Analog Signal Path Chapter 5: Q
Page 48 and 49: Sweeps Chapter 5: Quick Guides Swee
Page 50 and 51: Sweeps Chapter 5: Quick Guides To c
Page 52 and 53: Sweeps Chapter 5: Quick Guides fiel
Page 54 and 55: DSP Analysis Chapter 5: Quick Guide
Page 56 and 57: The FFT Spectrum Analyzer Chapter 5
Page 58 and 59: The FFT Spectrum Analyzer Chapter 5
Page 60 and 61: Chapter 6 Specifications Analog Sig
Page 62 and 63: Analog Signal Outputs Chapter 6: Sp
Page 64 and 65: D/A Generated Analog Signals Chapte
Page 66 and 67: D/A Generated Analog Signals Chapte
Page 68 and 69: Analog Analyzer Chapter 6: Specific
Page 74 and 75: Option Filters Chapter 6: Specifica
Page 76 and 77: Option Filters Chapter 6: Specifica
Page 78 and 79: Option S-AES17 Chapter 6: Specifica
Page 80 and 81: DSP Analysis of Analog Signals Chap
Page 82 and 83: DSP Analysis of Analog Signals Chap
Page 84 and 85: Digital Signal Generator Chapter 6:
Page 92 and 93: Digital Analyzer Chapter 6: Specifi
Page 94 and 95: Digital Analyzer Chapter 6: Specifi
Page 96 and 97: Rear Panel Auxiliary Signals Chapte
Page 98 and 99: General/Environmental Chapter 6: Sp
Page 100 and 101: Digital Audio Cables Chapter 6: Spe
show all

Getting Started with Your 2700 Series Instrument

Create successful ePaper yourself

Delete template?

Save as template?