2013 Infiniti | Navigation System Owner's Manual - Infiniti Owner ...

4. Setting destination
IDE0152
5. The entire route is shown on the map.
Highlight [Start] after confirming the
location of the displayed destination,
and push . The system sets the
destination to the selected location and
starts calculating a route.
4-18
INFO:
. Even after setting a destination, the location
of the destination can be adjusted, the
location can be stored, etc.
“Procedures after setting destination”
(page 5-2)
. The stored route includes only locations
(destination and waypoints) and route
calculation conditions, not the route itself.
Therefore, when the destination is set using
a stored route, a different route may be
suggested if the current vehicle location is
different from the one when the route was
stored.
SETTING BY PHONE NUMBER
If the phone number of a facility is known,
it is possible to search for a facility by
entering the phone number, and have the
system calculate a route.
INFO:
. Telephone numbers that were stored for
stored destinations can also be used.
. If the area code of the specified telephone
number does not exist in the map data, the
system cannot search for the location.
. Only the locations included in the database
in the map data can be searched by the
phone number. Residential phone numbers
cannot be used to search for a location.
JND0248X
1. Push .
2. Highlight [Next Page] and push
.
IDE0154
3. Highlight [Phone Number] and push
. The telephone number input
screen is displayed.
IDE0155
4. Enter the telephone number including
the area code.
5. After finishing the entry, highlight [List]
and push .
“Number input screen”