UltiMate 3000 SRD-3x00 Solvent Racks - Dionex

UltiMate 3000 Series:
SRD-3x00 Solvent Racks
3. Remove the foam spacers, and then remove the polythene packaging.
4. Before connecting the instrument to the power source, wait approximately four hours
to allow the instrument to come to room temperature and to allow any condensation
that might have occurred during shipping to evaporate. After four hours, check the
SRD; if condensation still exists, allow the instrument to continue to warm up (without
connecting it to the power source) until the condensation is completely gone.
3.3 Positioning the SRD in the UltiMate 3000 System
If the SRD is part of an UltiMate 3000 system, for example, for analytical HPLC
applications, you should stack the individual modules, for example, as shown in Fig. 4 and
interconnect them on the rear panel as shown in Fig. 5. However, the arrangement of the
system modules depends on the application.
Fig. 4: Module arrangement for an UltiMate 3000 system (example)
Solvent Rack
Pump
Autosampler
Column compartment
Detector
If the solvent rack is part of an UltiMate 3000 RSLCnano system or Proteomics MDLC
system, the related system manual ('UltiMate RSLCnano - Standard Applications' or
'UltiMate 3000 Proteomics MDLC - System Installation and Application') provides
information about how to arrange the modules and set up the system for these applications.
Page 16 Operating Instructions