UltiMate 3000 SRD-3x00 Solvent Racks - Dionex

UltiMate 3000 Series:
SRD-3x00 Solvent Racks
3.4 Connecting the SRD
3.4.1 Connecting the SRD to an UltiMate 3000 System Pump
Locate the connection cable in the accessories kit of the SRD and connect the 15-pin D-
Sub port on the rear panel with the Solvent Rack port on the rear panel of the pump. To
ensure trouble-free operation, use only the cable shipped with the instrument.
When the SRD is connected to the pump, the solvent rack is powered from the pump. The
SRD need not be connected directly to the main power supply.
For information about the pin assignment for the 15-pin D-Sub connector, see page 51.
3.4.2 Connecting the SRD to the Main Power Supply (Optional)
The SRD needs to be connected to the main power supply only if it is not operated from an
UltiMate 3000 system pump. For this scenario, an external power supply (part no.
6510.0004) is available as an option for the SRD.
Use the external power supply unit to connect the DC input on the rear panel to a power
source that is connected to a true ground. No manual adjustment is required to adapt the line
voltage to local voltage requirements.
Important: Do not connect the external power supply unit when the SRD is
connected to an UltiMate 3000 system pump (→ section 3.4.1).
Important: N'utilisez pas d'alimentation électrique externe si l'instrument est
raccordé un pompe du système UltiMate 3000 (→ chapitre 3.4.1).
Page 18 Operating Instructions