Users Manual - Warranty Life

Chapter 9 Beeper, Indicator LED and Vibrator
9.1 Beeper
(1) Beeping
The scanner emits a short, long, one-shot, or intermittent beep to indicate the scanner status as described below. The
intermittent and one-shot beeps apply when the scanner reads an RSS-14 Stacked or RSS-14 Stacked Omnidirectional
symbol.
The beeper can be disabled with the bar-coded parameter menu or configuration software (ScannerSetting); however,
in some cases it sounds regardless of the beeper setting. For details, see the next page.
Note: Whether to enable or disable the beeper when the scanner reads RSS-14 Stacked or RSS-14 Stacked
Omnidirectional symbols can be selected with the "Beeper when reading RSS-14 Stacked/RSS-14 Stacked
Omnidirectional" bar code on the bar-coded parameter menu. The "Beeper" bar code for other bar codes has no effect
on RSS-14 Stacked or RSS-14 Stacked Omnidirectional symbols.
A short beep (60, 80, or 120 ms selectable* 1) when:
• a read of a bar code is successfully complete,
• master data registration is successfully complete in the verification setup procedure,
• bar code data read matches the master data in the data verification mode,
• data retransfer or specific character transfer with the magic key is complete,
• bar code data read in the specified data editing matches the editing conditions,
• the scanner has read a parameter setting bar code from the bar-coded parameter menu (given in Chapter 12), or
• the scanner has read the "DATA" bar code out of batch-process bar code symbols generated with the configuration
software.
A short beep of 60 ms when:
• the "Start setting" or "End setting" bar code is read from the bar-coded parameter menu (given in Chapter 12),
• the scanner has read the "START" or "END" bar code out of batch-process bar code symbols generated with the
configuration software,
• the configuration software starts up or accepts new setting, or
• the setting cannot be made because the "START" barcode from a batch-process barcode printed with a version of the
configuration software that does not match the scanner firmware was scanned.
A long beep of 180 ms when:
• parameter setting with the bar-coded parameter menu (given in Chapter 12) has failed.
A long beep of 480 ms when:
• a master bar code has the wrong number of digits during registration of master data,
• bar code data read does not match the master data in the data verification mode,
• bar code data read in the specified data editing does not match the editing conditions, resulting in no transfer,
• a transmission error or timeout has occurred during communication with the configuration software
(ScannerSetting),
• a communications error has occurred,
• the previously sent data is not available at the time of data retransfer (using the magic key),
• three minutes have elapsed without scanning any parameter setting bar code from the bar-coded parameter menu
(given in Chapter 12) in the parameter setting procedure, or
• there is a possibility of an abnormal setting because the "END" barcode from a batch-process barcode printed with a
version of the configuration software that does not match the scanner firmware was scanned.
29