DCP Series X.25 Packet Switched Communications Software (PSCS ...

More documents

Recommendations

Info

DCP Series X.25 Packet Switched Communications Software (PSCS) Configuration and Operations Guide Copyright© 1994 Unisys Corporation. All rights reserved. Unisys is a registered trademark of Unisys Corporation. 5R2D December 1994 Printed in U S America Priced Item 7831 5470–200
NO WARRANTIES OF ANY NATURE ARE EXTENDED BY THE DOCUMENT. Any product and related material disclosed herein are only furnished pursuant and subject to the terms and conditions of a duly executed agreement to purchase or lease equipment or to license software. The only warranties made by Unisys Corporation, if any, with respect to the products described in this document are set forth in such agreement. Unisys Corporation cannot accept any financial or other responsibility that may be the result of your use of the information in this document or software material, including direct, indirect, special, or consequential damages. You should be very careful to ensure that the use of this information and/or software material complies with the laws, rules, and regulations of the jurisdictions with respect to which it is used. The information contained herein is subject to change without notice. Revisions may be issued to advise of such changes and/or additions. Correspondence regarding this publication should be forwarded to Unisys Corporation by addressing remarks to Communication Systems Product Information, Salt Lake City Publications, MS B2B07, 322 North 2200 West, Salt Lake City, UT 84116-2979, U.S.A. Telenet is a registered trademark of General Telephone and Electronics Corporation. UNISCOPE is a registered trademark of Unisys Corporation. UNIX is a registered trademark of X/Open Company Limited.
Page 1: Product Information Announcement Ne
Page 5 and 6: Contents vi Section 2. Configuring
Page 7 and 8: Contents viii 5.6. SWITCH — Rerou
Page 9 and 10: Contents x Appendix A. X.25 PSCS Re
Page 11 and 12: Figures xii 4-16. X.29 PAD with Con
Page 13 and 14: About This Guide Purpose Scope The
Page 15 and 16: Section Description Section 4 Confi
Page 17 and 18: Related Product Information About T
Page 19 and 20: Document Name/Number Description DC
Page 21 and 22: Section 1 Introduction Section 1 pr
Page 23 and 24: 1.1. X.25 PSCS Product Overview Int
Page 25 and 26: 1.1.3. Idle Trunk Circuit Handling
Page 27 and 28: SNA DCA Introduction X.25 PSCS prov
Page 29 and 30: • Reverse charging, which enables
Page 31 and 32: 1.2. X.25 PSCS Limitations X.25 PSC
Page 33 and 34: 1.4. DCE Network Limitations The DC
Page 35 and 36: 1.6. Migration Issues Introduction
Page 37 and 38: 1.6.2. Level 4 Program Definition f
Page 39 and 40: Configuring Standard X.25 PSCS Capa
Page 53 and 54:
Configuring Standard X.25 PSCS Capa
Page 55 and 56:
Page 57 and 58:
Page 59 and 60:
Page 61 and 62:
Page 63 and 64:
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Section 3 Configuring a DCE Network
Page 83 and 84:
3.1 Planning the Network Configurin
Page 85 and 86:
3.1.2 Rules for Creating Network Ad
Page 87 and 88:
Figure 3-3 illustrates address comp
Page 89 and 90:
• At least one X25DEF statement t
Page 91 and 92:
Procedure Provide the following sta
Page 93 and 94:
3.2.2 Adding a Node and DTEs to a D
Page 95 and 96:
Example Configuring a DCE Network
Page 97 and 98:
Procedure Configuring a DCE Network
Page 99 and 100:
Configuring a DCE Network ———
Page 101 and 102:
Procedure Provide the following add
Page 103 and 104:
Configuring a DCE Network
Page 105 and 106:
Procedure Provide the following add
Page 107 and 108:
Configuring a DCE Network 3.3 Confi
Page 109 and 110:
Configuring a DCE Network When DTED
Page 111 and 112:
3.3.3 Configuring Reverse Charging
Page 113 and 114:
3.3.5 Configuring DTE Hunt Groups P
Page 115 and 116:
3.3.6 Configuring DTE Subaddresses
Page 117 and 118:
3.3.7 Configuring an ILM-20 Connect
Page 119 and 120:
Example Configuring a DCE Network T
Page 121 and 122:
Configuration Examples 4-2 Section
Page 123 and 124:
Configuration Examples CMS configur
Page 125 and 126:
Configuration Examples 4-6
Page 127 and 128:
Configuration Examples 4.2 DCP-to-D
Page 129 and 130:
Configuration Examples Telcon confi
Page 131 and 132:
Page 133 and 134:
Configuration Examples 4.3 DCP-to-D
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Page 143 and 144:
Configuration Examples 4.5 DCP-to-U
Page 145 and 146:
Page 147 and 148:
Configuration Examples 4-28 Figure
Page 149 and 150:
Page 151 and 152:
Page 153 and 154:
Page 155 and 156:
Page 157 and 158:
Configuration Examples 4.8 X.29 PAD
Page 159 and 160:
Page 161 and 162:
Configuration Examples 4-42 Figure
Page 163 and 164:
Page 165 and 166:
Page 167 and 168:
Configuration Examples 4.10 Two-Nod
Page 169 and 170:
Page 171 and 172:
Page 173 and 174:
Section 5 Using Network Management
Page 175 and 176:
Using Network Management Services (
Page 177 and 178:
TERM=name A terminal to deactivate.
Page 179 and 180:
Figure 5-1 is an example of LIST LI
Page 181 and 182:
5.4 RECORD — Controlling DCE Netw
Page 183 and 184:
5.5 STAT — Displaying Status Form
Page 185 and 186:
5.5.1 STAT LINE Display STAT Figure
Page 187 and 188:
5.5.2 STAT PDTE Display Figure 5-3
Page 189 and 190:
5.5.3 STAT PTRK Display Figure 5-4
Page 191 and 192:
5.6 SWITCH — Rerouting Call Packe
Page 193 and 194:
5.7 TRAC — Message Tracing TRAC T
Page 195 and 196:
DATA Fields for the Items to Trace
Page 197 and 198:
Example 2 Example 2 sets the file s
Page 199 and 200:
5.7.2 TRAC SNAP DCEF Format The TRA
Page 201 and 202:
5.8 UP — Activating a Facility Fo
Page 203 and 204:
Section 6 Using X.25 PSCS Configura
Page 205 and 206:
Section Topic Using X.25 PSCS Confi
Page 207 and 208:
6.2. DTE — Defining Data Terminal
Page 209 and 210:
DCATS=sname A DCATS statement. Use
Page 211 and 212:
RPOA=dnic Specifies the data networ
Page 213 and 214:
6.2.2. DTEs on DCE Networks Format
Page 215 and 216:
Examples DCECUG=(opt,a[,b][,c][,d])
Page 217 and 218:
6.3. DTETYPE — Defining DTE Commu
Page 219 and 220:
X29PAD Specifies an X.29 network PA
Page 221 and 222:
PAKSIZ=(ipps[,opps]) DTETYPE Specif
Page 223 and 224:
Examples Example 1 DTETYPE Example
Page 225 and 226:
6.3.2. DTETYPEs for DCE Networks Fo
Page 227 and 228:
6.4. EU — Defining X.25 PSCS End
Page 229 and 230:
Accunet (USA) Arpac (Argentina) Aus
Page 231 and 232:
Example 4 Example 4 provides the sa
Page 233 and 234:
Example The following example defin
Page 235 and 236:
Example The following example shows
Page 237 and 238:
6.5.2. LCLASS For ILM-20 Lines Form
Page 239 and 240:
Example 2 LINE Example 2 defines a
Page 241 and 242:
6.7.1. PDNGRPs for PDNs and Private
Page 243 and 244:
Examples OPTIONS=(opt1,opt2,...) Sp
Page 245 and 246:
6.7.2. PDNGRPs for the DDN Format P
Page 247 and 248:
IMP=(psn) PDNGRP Specifies an IMP o
Page 249 and 250:
6.7.3. PDNGRPs for DCE Networks For
Page 251 and 252:
Online configuration differences PD
Page 253 and 254:
X3P02=value Defines echo function.
Page 255 and 256:
X3P10=value Defines the line foldin
Page 257 and 258:
X3P19=value X3P20 X3P21 Defines the
Page 259 and 260:
Example 2 PDNPAD Example 2 defines
Page 261 and 262:
Example The following example defin
Page 263 and 264:
6.10. X25DEF — Defining Network C
Page 265 and 266:
Table 6-3. Network Names and Mnemon
Page 267 and 268:
Parameters NAME='net-name' X25DEF S
Page 269 and 270:
DTETYPE=dtype X25DEF Specifies a DT
Page 271 and 272:
L3OPT=(option1,...,option31) Level
Page 273 and 274:
Examples Example 1 Example 1 define
Page 275 and 276:
6.11. X25NET — Defining DCE Netwo
Page 277 and 278:
6.12. X25ROUTE — Specifying Routi
Page 279 and 280:
Example PROTOCOL=(lvl4[,lvl4]...)(A
Page 281 and 282:
Section 7 X.25 PSCS Troubleshooting
Page 283 and 284:
7.2 Verifying Line Operation X.25 P
Page 285 and 286:
7.2.1.2 Determining If X.25 PSCS In
Page 287 and 288:
X.25 PSCS Troubleshooting DCP/OS al
Page 289 and 290:
7.2.2.1 Physical Layer Connection X
Page 291 and 292:
7.3 Verifying Virtual Circuit Conne
Page 293 and 294:
7.3.3 Connection Troubleshooting Ac
Page 295 and 296:
7.4 Verifying Message Data Transfer
Page 297 and 298:
7.4.1.3 Determining Adequate DCP/OS
Page 299 and 300:
Facility Constraints X.25 PSCS Trou
Page 301 and 302:
Appendix A X.25 PSCS Reserved Words
Page 303 and 304:
X.25 PSCS Outgoing Call Routing Con
Page 305 and 306:
X.25 PSCS Outgoing Call Routing Con
Page 307 and 308:
NMS TRAC Command Trace File Formats
Page 309 and 310:
NMS TRAC Command Trace File Formats
Page 311 and 312:
Glossary A asynchronous transmissio
Page 313 and 314:
Glossary data unit control (DUC) Th
Page 315 and 316:
DTP DTPX DUC E See DCA transport pr
Page 317 and 318:
Glossary hunt group An optional X.2
Page 319 and 320:
Glossary logical channel A network
Page 321 and 322:
Glossary packet layer services (PLS
Page 323 and 324:
Glossary Recommendation X.29 A ITU/
Page 325 and 326:
U U Series The family of U 6000 har
Page 327 and 328:
Index A Accunet, 1-7, 6-27, 6-63 to
Page 329 and 330:
Datapac, 1-7, 6-27, 6-63 to 6-64 Da
Page 331 and 332:
M M-bit implementation feature desc
Page 333 and 334:
tracing messages, 5-21 transit dela
show all

DCP Series X.25 Packet Switched Communications Software (PSCS ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?