DCP Series X.25 Packet Switched Communications Software (PSCS ...

More documents

Recommendations

Info

Example Configuring Standard X.25 PSCS Capabilities The following example shows a DCP-to-DCP trunk configuration. The LEVEL4 parameter on the DTETYPE statement specifies PDNTRUNK. The DTETYPE also defines a maximum of ten switched virtual circuits for this trunk and the following values for idle trunk handling: • 10 attempts to reestablish a virtual circuit that has been cleared • 90 seconds between attempts to reestablish a virtual circuit that has been cleared • 90 seconds between transmission of NDUs before a circuit is cleared • A diagnostic code of 150 to indicate that a trunk is in an idle state ——————————————————————————————————————— 7831 5470–200 2–13
Configuring Standard X.25 PSCS Capabilities 2.2.2 Configuring a UTS 4000 Cluster Controller as a DTE 2–14 This section describes how to define a UTS 4000 Cluster Controller running UTS X.25 PSCS software as a DTE. It builds on the basic network connections described in Section 2.1.1, “Configuring a Connection to a PDN” and Section 2.1.3, “Configuring a Multilink Connection.” Since the DDN requires the TCP/IP protocols, do not use the procedures described in Section 2.1.2, “Configuring a Connection to the DDN,” with this procedure. Figure 2–5 illustrates this configuration. Note: UTS 4000 Cluster Controllers must be defined as DTEs. Figure 2–5. Cluster Controller Configured as a DTE ——————————————————————————————————————— 7831 5470–200
Page 1 and 2: Product Information Announcement Ne
Page 3 and 4: NO WARRANTIES OF ANY NATURE ARE EXT
Page 5 and 6: Contents vi Section 2. Configuring
Page 7 and 8: Contents viii 5.6. SWITCH — Rerou
Page 9 and 10: Contents x Appendix A. X.25 PSCS Re
Page 11 and 12: Figures xii 4-16. X.29 PAD with Con
Page 13 and 14: About This Guide Purpose Scope The
Page 15 and 16: Section Description Section 4 Confi
Page 17 and 18: Related Product Information About T
Page 19 and 20: Document Name/Number Description DC
Page 21 and 22: Section 1 Introduction Section 1 pr
Page 23 and 24: 1.1. X.25 PSCS Product Overview Int
Page 25 and 26: 1.1.3. Idle Trunk Circuit Handling
Page 27 and 28: SNA DCA Introduction X.25 PSCS prov
Page 29 and 30: • Reverse charging, which enables
Page 31 and 32: 1.2. X.25 PSCS Limitations X.25 PSC
Page 33 and 34: 1.4. DCE Network Limitations The DC
Page 35 and 36: 1.6. Migration Issues Introduction
Page 37 and 38: 1.6.2. Level 4 Program Definition f
Page 39 and 40: Configuring Standard X.25 PSCS Capa
Page 49: Configuring Standard X.25 PSCS Capa
Page 81 and 82: Section 3 Configuring a DCE Network
Page 83 and 84: 3.1 Planning the Network Configurin
Page 85 and 86: 3.1.2 Rules for Creating Network Ad
Page 87 and 88: Figure 3-3 illustrates address comp
Page 89 and 90: • At least one X25DEF statement t
Page 91 and 92: Procedure Provide the following sta
Page 93 and 94: 3.2.2 Adding a Node and DTEs to a D
Page 95 and 96: Example Configuring a DCE Network
Page 97 and 98: Procedure Configuring a DCE Network
Page 99 and 100: Configuring a DCE Network ———
Page 101 and 102:
Procedure Provide the following add
Page 103 and 104:
Configuring a DCE Network
Page 105 and 106:
Procedure Provide the following add
Page 107 and 108:
Configuring a DCE Network 3.3 Confi
Page 109 and 110:
Configuring a DCE Network When DTED
Page 111 and 112:
3.3.3 Configuring Reverse Charging
Page 113 and 114:
3.3.5 Configuring DTE Hunt Groups P
Page 115 and 116:
3.3.6 Configuring DTE Subaddresses
Page 117 and 118:
3.3.7 Configuring an ILM-20 Connect
Page 119 and 120:
Example Configuring a DCE Network T
Page 121 and 122:
Configuration Examples 4-2 Section
Page 123 and 124:
Configuration Examples CMS configur
Page 125 and 126:
Configuration Examples 4-6
Page 127 and 128:
Configuration Examples 4.2 DCP-to-D
Page 129 and 130:
Configuration Examples Telcon confi
Page 131 and 132:
Page 133 and 134:
Configuration Examples 4.3 DCP-to-D
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Page 143 and 144:
Configuration Examples 4.5 DCP-to-U
Page 145 and 146:
Page 147 and 148:
Configuration Examples 4-28 Figure
Page 149 and 150:
Page 151 and 152:
Page 153 and 154:
Page 155 and 156:
Page 157 and 158:
Configuration Examples 4.8 X.29 PAD
Page 159 and 160:
Page 161 and 162:
Configuration Examples 4-42 Figure
Page 163 and 164:
Page 165 and 166:
Page 167 and 168:
Configuration Examples 4.10 Two-Nod
Page 169 and 170:
Page 171 and 172:
Page 173 and 174:
Section 5 Using Network Management
Page 175 and 176:
Using Network Management Services (
Page 177 and 178:
TERM=name A terminal to deactivate.
Page 179 and 180:
Figure 5-1 is an example of LIST LI
Page 181 and 182:
5.4 RECORD — Controlling DCE Netw
Page 183 and 184:
5.5 STAT — Displaying Status Form
Page 185 and 186:
5.5.1 STAT LINE Display STAT Figure
Page 187 and 188:
5.5.2 STAT PDTE Display Figure 5-3
Page 189 and 190:
5.5.3 STAT PTRK Display Figure 5-4
Page 191 and 192:
5.6 SWITCH — Rerouting Call Packe
Page 193 and 194:
5.7 TRAC — Message Tracing TRAC T
Page 195 and 196:
DATA Fields for the Items to Trace
Page 197 and 198:
Example 2 Example 2 sets the file s
Page 199 and 200:
5.7.2 TRAC SNAP DCEF Format The TRA
Page 201 and 202:
5.8 UP — Activating a Facility Fo
Page 203 and 204:
Section 6 Using X.25 PSCS Configura
Page 205 and 206:
Section Topic Using X.25 PSCS Confi
Page 207 and 208:
6.2. DTE — Defining Data Terminal
Page 209 and 210:
DCATS=sname A DCATS statement. Use
Page 211 and 212:
RPOA=dnic Specifies the data networ
Page 213 and 214:
6.2.2. DTEs on DCE Networks Format
Page 215 and 216:
Examples DCECUG=(opt,a[,b][,c][,d])
Page 217 and 218:
6.3. DTETYPE — Defining DTE Commu
Page 219 and 220:
X29PAD Specifies an X.29 network PA
Page 221 and 222:
PAKSIZ=(ipps[,opps]) DTETYPE Specif
Page 223 and 224:
Examples Example 1 DTETYPE Example
Page 225 and 226:
6.3.2. DTETYPEs for DCE Networks Fo
Page 227 and 228:
6.4. EU — Defining X.25 PSCS End
Page 229 and 230:
Accunet (USA) Arpac (Argentina) Aus
Page 231 and 232:
Example 4 Example 4 provides the sa
Page 233 and 234:
Example The following example defin
Page 235 and 236:
Example The following example shows
Page 237 and 238:
6.5.2. LCLASS For ILM-20 Lines Form
Page 239 and 240:
Example 2 LINE Example 2 defines a
Page 241 and 242:
6.7.1. PDNGRPs for PDNs and Private
Page 243 and 244:
Examples OPTIONS=(opt1,opt2,...) Sp
Page 245 and 246:
6.7.2. PDNGRPs for the DDN Format P
Page 247 and 248:
IMP=(psn) PDNGRP Specifies an IMP o
Page 249 and 250:
6.7.3. PDNGRPs for DCE Networks For
Page 251 and 252:
Online configuration differences PD
Page 253 and 254:
X3P02=value Defines echo function.
Page 255 and 256:
X3P10=value Defines the line foldin
Page 257 and 258:
X3P19=value X3P20 X3P21 Defines the
Page 259 and 260:
Example 2 PDNPAD Example 2 defines
Page 261 and 262:
Example The following example defin
Page 263 and 264:
6.10. X25DEF — Defining Network C
Page 265 and 266:
Table 6-3. Network Names and Mnemon
Page 267 and 268:
Parameters NAME='net-name' X25DEF S
Page 269 and 270:
DTETYPE=dtype X25DEF Specifies a DT
Page 271 and 272:
L3OPT=(option1,...,option31) Level
Page 273 and 274:
Examples Example 1 Example 1 define
Page 275 and 276:
6.11. X25NET — Defining DCE Netwo
Page 277 and 278:
6.12. X25ROUTE — Specifying Routi
Page 279 and 280:
Example PROTOCOL=(lvl4[,lvl4]...)(A
Page 281 and 282:
Section 7 X.25 PSCS Troubleshooting
Page 283 and 284:
7.2 Verifying Line Operation X.25 P
Page 285 and 286:
7.2.1.2 Determining If X.25 PSCS In
Page 287 and 288:
X.25 PSCS Troubleshooting DCP/OS al
Page 289 and 290:
7.2.2.1 Physical Layer Connection X
Page 291 and 292:
7.3 Verifying Virtual Circuit Conne
Page 293 and 294:
7.3.3 Connection Troubleshooting Ac
Page 295 and 296:
7.4 Verifying Message Data Transfer
Page 297 and 298:
7.4.1.3 Determining Adequate DCP/OS
Page 299 and 300:
Facility Constraints X.25 PSCS Trou
Page 301 and 302:
Appendix A X.25 PSCS Reserved Words
Page 303 and 304:
X.25 PSCS Outgoing Call Routing Con
Page 305 and 306:
X.25 PSCS Outgoing Call Routing Con
Page 307 and 308:
NMS TRAC Command Trace File Formats
Page 309 and 310:
NMS TRAC Command Trace File Formats
Page 311 and 312:
Glossary A asynchronous transmissio
Page 313 and 314:
Glossary data unit control (DUC) Th
Page 315 and 316:
DTP DTPX DUC E See DCA transport pr
Page 317 and 318:
Glossary hunt group An optional X.2
Page 319 and 320:
Glossary logical channel A network
Page 321 and 322:
Glossary packet layer services (PLS
Page 323 and 324:
Glossary Recommendation X.29 A ITU/
Page 325 and 326:
U U Series The family of U 6000 har
Page 327 and 328:
Index A Accunet, 1-7, 6-27, 6-63 to
Page 329 and 330:
Datapac, 1-7, 6-27, 6-63 to 6-64 Da
Page 331 and 332:
M M-bit implementation feature desc
Page 333 and 334:
tracing messages, 5-21 transit dela
show all

DCP Series X.25 Packet Switched Communications Software (PSCS ...

Create successful ePaper yourself

Delete template?

Save as template?