OPERATION MANUAL

Instruction Execution Times and Number of Steps Section 10-5
DOUBLE
COMPARE
SIGNED
BINARY COM-
PARE
DOUBLE
SIGNED
BINARY COM-
PARE
TABLE COM-
PARE
MULTIPLE
COMPARE
UNSIGNED
BLOCK COM-
PARE
AREA RANGE
COMPARE
DOUBLE
AREA RANGE
COMPARE
516
Instruction Mnemonic Code Length
(steps)
(See note.)
CMPL 060 3 0.08 0.08 0.25 0.46 ---
CPS 114 3 0.08 0.08 6.50 6.50 ---
!CPS 114 7 +35.9 +35.9 +42.4 +42.4 Increase for
CS Series
+84.1 +84.1 +90.5 +90.5 Increase for
C200H
CPSL 115 3 0.08 0.08 6.50 6.50 ---
TCMP 085 4 14.0 15.2 21.9 21.9 ---
MCMP 019 4 20.5 22.8 31.2 31.2 ---
BCMP 068 4 21.5 23.7 32.6 32.6 ---
ZCP 088 3 5.3 5.4 --- --- ---
ZCPL 116 3 5.5 6.7 --- --- ---
Note 1. When a double-length operand is used, add 1 to the value shown in the
length column in the following table.
10-5-6 Data Movement Instructions
ON execution time (µs) Conditions
CPU-6@H CPU-4@H CPU-6@CPU-4@ 2. Supported only by CPU Units Ver. 2.0 or later.
Instruction Mnemonic Code Length
ON execution time (µs) Conditions
(steps)
(See note.)
CPU-6@H CPU-4@H CPU-6@CPU-4@ MOVE MOV 021 3 0.18 0.20 0.25 0.29 ---
!MOV 021 7 +21.38 +21.40 +42.36 +42.36 Increase for CS
Series
+90.52 +90.52 +90.52 +90.52 Increase for
C200H
DOUBLE
MOVE
MOVL 498 3 0.32 0.34 0.42 0.50 ---
MOVE NOT MVN 022 3 0.18 0.20 0.25 0.29 ---
DOUBLE
MOVE NOT
MVNL 499 3 0.32 0.34 0.42 0.50 ---
MOVE BIT MOVB 082 4 0.24 0.34 7.5 7.5 ---
MOVE DIGIT MOVD 083 4 0.24 0.34 7.3 7.3 ---
MULTIPLE
BIT TRANS-
FER
BLOCK
TRANSFER
XFRB 062 4 10.1 10.8 13.6 13.6 Transferring 1
bit
186.4 189.8 269.2 269.2 Transferring 255
bits
XFER 070 4 0.36 0.44 11.2 11.2 Transferring 1
word
300.1 380.1 633.5 633.5 Transferring
1,000 words