CMN-91 Compact Video and Audio Monitor ... - Biznine.com

More documents

Recommendations

Info

Section 2 ♦ Installation Installing the Optional Battery Mount WARNING: Do not puncture, damage, or discard batteries in fire. The batteries can explode, releasing hazardous chemicals. Dispose of the batteries according to the instructions of the battery manufacturer and in accordance with local laws. The CMN-91 unit can use an optional lithium ion battery for remote operation. • When using the Anton-Bauer Gold Mount, customers should use an Anton Bauer Dionic 90 lithium ion battery. Visit www.antonbauer.com/WhereToBuy for ordering information. • When using the IDX V-Mount, customers should use an IDX Endura-7, -7S, -10, or -10S battery. Visit http://www.idxtek.com/dealer_locator/ for ordering information. If the battery mount was not purchased with the unit, perform the following: 1. Remove the portable case from the CMN-91. Set all mounting hardware aside, as you will use it to reinstall the portable case. 2. Remove the cover from the CMN-91. Set all mounting hardware aside, as you will use it to reinstall the cover. 3. Using a flat blade screw driver, twist the slug out of the rear of the cover. 4. Acquire the battery mount and the spacer plate. Insert the rubber grommet on the battery mount wires into the spacer plate. 5. Pass the connector housing on the end of the battery mount wires through the hole in the cover. 6. Plug the connector into the five-position header on the CMN101 board. 7. Slide the cover back onto the chassis and reinstall the screws. 8. Reinstall the portable case. 9. Mount the battery mount and spacer plate using the four screws included in the kit. Charging the Battery The CMN-91 does not charge the battery when using the AC adapter. See the manufacturer’s documentation for instructions on charging or recharging your selected battery. 8 CMN-91 Series Installation and Operation Handbook Copyright © 2009, Harris Corporation
Rack Mounting the CMN-91 Section 2 ♦ Installation CAUTION: The CMN-91 should not be installed in a DRC-1 case. If installed in a DRC-1 case, the unit will overheat. When selecting the permanent mounting location for the CMN-91, make sure that the flow of air to the ventilation holes on the top and sides of the chassis is not obstructed. Rack mounting the CMN-91 is illustrated in Figure 2-1 for the DRC-3 rack mount case, and in Figure 2-2 for the DRC-2A double rack mount case (for installing one or two CMN-91 units). Table 2-1 lists the parts required to rack mount the CMN-91 into the DRC-3 rack mount case and Table 2-2 lists the parts required to rack mount the CMN-91 into the DRC-2A double rack mount case. Figure 2-1. Mounting the CMN-91 in a Rack Using the DRC-3 NOTE: Although only one CMN-91 unit is shown in Figure 2-1, two CMN-91 units may be mounted into a DRC-3 rack case. Table 2-1. Parts Required to Rack Mount the CMN-91 Using the DRC-3 Key Item Number Qty Description 1 — A/R CMN-91 unit 2 866078 1 DRC-3 rack case 3 831030 4 #10-32×¾-in. Phillips head screws 4 831019 4 Nylon washer, rack mount CMN-91 Series Installation and Operation Handbook 9 Copyright © 2009, Harris Corporation
Page 1: CMN-91 Compact Video and Audio Moni
Page 4 and 5: Ensuring Safety Operator’s Safety
Page 6 and 7: Operator’s Safety Summary This pa
Page 8 and 9: Directives and Compliances In accor
Page 10 and 11: Contents Selecting an Input .......
Page 12 and 13: Contents Video Setup Menu Selection
Page 14 and 15: Contents GNU Lesser Public License
Page 16 and 17: Contents Table 1-6. SD Formats ....
Page 18 and 19: Contents This page is intentionally
Page 20 and 21: Section 1 ♦ Introduction • XGA,
Page 22 and 23: Table 1-4. Dual Link Formats Sectio
Page 24 and 25: Service and Support Section 1 ♦ I
Page 28 and 29: Section 2 ♦ Installation Table 2-
Page 30 and 31: Section 2 ♦ Installation Table 2-
Page 32 and 33: Connecting the CMN-91 Section 2 ♦
Page 34 and 35: Section 2 ♦ Installation • For
Page 36 and 37: Section 2 ♦ Installation This pag
Page 38 and 39: Section 3 ♦ General Information
Page 40 and 41: Table 3-1. CMN-91 Front Panel Contr
Page 42 and 43: Figure 3-4. Overlay Display Table 3
Page 44 and 45: Section 3 ♦ General Information A
Page 46 and 47: Recalling Captured Data Section 3
Page 48 and 49: Figure 4-1. Waveform Display Diagra
Page 50 and 51: Section 4 ♦ Operating the CMN-91
Page 52 and 53: Figure 4-6. Establishing the Gain S
Page 56 and 57: Figure 4-11. Vector NTSC Zoom Upper
Page 58 and 59: Figure 4-15. Vector PAL Zoom Center
Page 60 and 61: Figure 4-18. Establishing the Vecto
Page 68 and 69: Picture Display Section 4 ♦ Opera
Page 70 and 71: PIP Display Section 4 ♦ Operating
Page 74 and 75: Figure 4-31. Six Bar Graph Display
Page 76 and 77:
Figure 4-33. Sixteen Bar Graph Disp
Page 78 and 79:
Section 4 ♦ Operating the CMN-91
Page 80 and 81:
Page 82 and 83:
Page 84 and 85:
Figure 4-37. LTC Display Diagram Se
Page 86 and 87:
Section 5 ♦ Global Setup Menu Fun
Page 88 and 89:
Page 90 and 91:
Page 92 and 93:
Page 94 and 95:
Page 96 and 97:
Page 98 and 99:
Page 100 and 101:
Page 102 and 103:
Page 104 and 105:
Page 106 and 107:
Page 108 and 109:
Page 110 and 111:
Page 112 and 113:
Page 114 and 115:
Section 6 ♦ Alarm Descriptions Ta
Page 116 and 117:
Page 118 and 119:
Page 120 and 121:
Section 6 ♦ Alarm Descriptions Au
Page 122 and 123:
Section 6 ♦ Alarm Descriptions Wh
Page 124 and 125:
Section 8 ♦ Troubleshooting This
Page 126 and 127:
Section 8 ♦ Troubleshooting Table
Page 128 and 129:
Appendix A ♦ Specifications Exter
Page 130 and 131:
Appendix A ♦ Specifications Wavef
Page 132 and 133:
Environmental Item Specification Op
Page 134 and 135:
Appendix B ♦ Pinouts Figure B-2.
Page 136 and 137:
Appendix B ♦ Pinouts This page is
Page 138 and 139:
Appendix C ♦ Open Source Software
Page 140 and 141:
Page 142 and 143:
Page 144 and 145:
The GNU v2 License Appendix C ♦ O
Page 146 and 147:
Page 148 and 149:
Page 150 and 151:
Page 152 and 153:
Page 154 and 155:
Page 156 and 157:
Page 158 and 159:
Appendix D ♦ Glossary Baseband Vi
Page 160 and 161:
Appendix D ♦ Glossary Editor A de
Page 162 and 163:
Appendix D ♦ Glossary High Defini
Page 164 and 165:
Appendix D ♦ Glossary NTSC Nation
Page 166 and 167:
Appendix D ♦ Glossary Segment Err
Page 168 and 169:
Appendix D ♦ Glossary This page i
Page 170 and 171:
DRC-2A rackmount, 11 DRC-3 rackmoun
Page 172:
SD-SDI, 109, 110 time code, 112 Sta
show all

CMN-91 Compact Video and Audio Monitor ... - Biznine.com

Create successful ePaper yourself

Delete template?

Save as template?