CMN-91 Compact Video and Audio Monitor ... - Biznine.com

More documents

Recommendations

Info

Section 2 ♦ Installation Table 2-1. Parts Required to Rack Mount the CMN-91 Using the DRC-3 Key Item Number Qty Description 5 831064 4 #8–32×½-in. Phillips head screws (CMN mtg) 6 831114 4 #8 Ext. tooth lock washers 7 832125 2 Optional metal rack ears, flush mount 8 832072 2 Metal extension mount 9 832070 2 Metal extension bracket 10 831119 8 #8–32 kep nuts 11 831064 4 #8–32×½-in. Phillips head screws 12 831118 8 #10 flat washers 13 831030 4 #10-32×¾-in. Phillips head screws 14 831060 4 #10–32 kep nuts 15 832131 1 Optional metal cover plate 16 831180 4 #4-40×¼ self-tapping Phillips head screws DRC-3 Rack Mount Installation These instructions are for installing units without the optional rack mounting extensions. For installing units with the optional extensions, see “DRC-3 Rack Mount with Rack Extensions Installation” on page 10. 1. Slide the CMN-91 unit (ITEM 1) in the DRC-3 rack case (ITEM 2). 2. Using ¾-in. Phillips head screws (ITEM 3) and lock washers (ITEM 4), secure the CMN-91 unit to the front of the DRC-3 rack case. 3. Using ½-in. Phillips head screws (ITEM 5) and lock washers (ITEM 6), secure the CMN-91 unit to the back of the DRC-3 rack case. 4. If desired, install the optional cover plate: • Slide the metal cover plate (ITEM 15) into the desired side of the DRC-3 rack. • Using 4 self tapping screws (ITEM 16), secure the cover plate into the DRC-3 rack. 5. The installation is complete. DRC-3 Rack Mount with Rack Extensions Installation NOTE: To install the optional flush mount rack ears (ITEM 7), first remove existing rack ears, but do not remove the metal spacers. Using the same hardware, attach the flush mount rack ears. 1. Install the extension bracket mounts (ITEM 8) to both sides of the DRC-3 chassis (ITEM 2) using 4 nuts (ITEM 10), as shown in Figure 2-1. 2. Install the assembled CMN-91 unit (ITEM 1) in the DRC-3 chassis (ITEM 2) using screws (ITEM 3) and washers (ITEM 4) through the chassis front mounting ears, as shown in Figure 2-1. 3. Hold the extension bracket (ITEM 9) in place on each side of chassis, and then loosely install the kep nuts (ITEM 10), screws, (ITEM 11), and washers (ITEM 12) into the proper holes that align with the slots in the metal extension mount (ITEM 8). 10 CMN-91 Series Installation and Operation Handbook Copyright © 2009, Harris Corporation
Section 2 ♦ Installation 4. Install the remaining hardware (ITEMS 12, 13, and 14) through the rack rails and the appropriate slots in the back of the bracket (ITEM 9), and then tighten the hardware. 6. Tighten the hardware (ITEMS 10, 11, and 12) that joins the bracket pairs. 7. If desired, install the optional cover plate. • Slide the metal cover plate (ITEM 15) into the desired side of the DRC-3 rack. • Using self-tapping screws (ITEM 16), secure the cover plate into the DRC-3 rack. 8. The installation is complete. DRC-2A Rack Mount Installation Figure 2-2. Mounting the CMN-91 in a Rack Using the DRC-2A NOTE: See Figure 2-3 for information about installing the flush mount rack ears. CMN-91 Series Installation and Operation Handbook 11 Copyright © 2009, Harris Corporation
Page 1: CMN-91 Compact Video and Audio Moni
Page 4 and 5: Ensuring Safety Operator’s Safety
Page 6 and 7: Operator’s Safety Summary This pa
Page 8 and 9: Directives and Compliances In accor
Page 10 and 11: Contents Selecting an Input .......
Page 12 and 13: Contents Video Setup Menu Selection
Page 14 and 15: Contents GNU Lesser Public License
Page 16 and 17: Contents Table 1-6. SD Formats ....
Page 18 and 19: Contents This page is intentionally
Page 20 and 21: Section 1 ♦ Introduction • XGA,
Page 22 and 23: Table 1-4. Dual Link Formats Sectio
Page 24 and 25: Service and Support Section 1 ♦ I
Page 26 and 27: Section 2 ♦ Installation Installi
Page 30 and 31: Section 2 ♦ Installation Table 2-
Page 32 and 33: Connecting the CMN-91 Section 2 ♦
Page 34 and 35: Section 2 ♦ Installation • For
Page 36 and 37: Section 2 ♦ Installation This pag
Page 38 and 39: Section 3 ♦ General Information
Page 40 and 41: Table 3-1. CMN-91 Front Panel Contr
Page 42 and 43: Figure 3-4. Overlay Display Table 3
Page 44 and 45: Section 3 ♦ General Information A
Page 46 and 47: Recalling Captured Data Section 3
Page 48 and 49: Figure 4-1. Waveform Display Diagra
Page 50 and 51: Section 4 ♦ Operating the CMN-91
Page 52 and 53: Figure 4-6. Establishing the Gain S
Page 56 and 57: Figure 4-11. Vector NTSC Zoom Upper
Page 58 and 59: Figure 4-15. Vector PAL Zoom Center
Page 60 and 61: Figure 4-18. Establishing the Vecto
Page 68 and 69: Picture Display Section 4 ♦ Opera
Page 70 and 71: PIP Display Section 4 ♦ Operating
Page 74 and 75: Figure 4-31. Six Bar Graph Display
Page 76 and 77: Figure 4-33. Sixteen Bar Graph Disp
Page 78 and 79:
Section 4 ♦ Operating the CMN-91
Page 80 and 81:
Page 82 and 83:
Page 84 and 85:
Figure 4-37. LTC Display Diagram Se
Page 86 and 87:
Section 5 ♦ Global Setup Menu Fun
Page 88 and 89:
Page 90 and 91:
Page 92 and 93:
Page 94 and 95:
Page 96 and 97:
Page 98 and 99:
Page 100 and 101:
Page 102 and 103:
Page 104 and 105:
Page 106 and 107:
Page 108 and 109:
Page 110 and 111:
Page 112 and 113:
Page 114 and 115:
Section 6 ♦ Alarm Descriptions Ta
Page 116 and 117:
Page 118 and 119:
Page 120 and 121:
Section 6 ♦ Alarm Descriptions Au
Page 122 and 123:
Section 6 ♦ Alarm Descriptions Wh
Page 124 and 125:
Section 8 ♦ Troubleshooting This
Page 126 and 127:
Section 8 ♦ Troubleshooting Table
Page 128 and 129:
Appendix A ♦ Specifications Exter
Page 130 and 131:
Appendix A ♦ Specifications Wavef
Page 132 and 133:
Environmental Item Specification Op
Page 134 and 135:
Appendix B ♦ Pinouts Figure B-2.
Page 136 and 137:
Appendix B ♦ Pinouts This page is
Page 138 and 139:
Appendix C ♦ Open Source Software
Page 140 and 141:
Page 142 and 143:
Page 144 and 145:
The GNU v2 License Appendix C ♦ O
Page 146 and 147:
Page 148 and 149:
Page 150 and 151:
Page 152 and 153:
Page 154 and 155:
Page 156 and 157:
Page 158 and 159:
Appendix D ♦ Glossary Baseband Vi
Page 160 and 161:
Appendix D ♦ Glossary Editor A de
Page 162 and 163:
Appendix D ♦ Glossary High Defini
Page 164 and 165:
Appendix D ♦ Glossary NTSC Nation
Page 166 and 167:
Appendix D ♦ Glossary Segment Err
Page 168 and 169:
Appendix D ♦ Glossary This page i
Page 170 and 171:
DRC-2A rackmount, 11 DRC-3 rackmoun
Page 172:
SD-SDI, 109, 110 time code, 112 Sta
show all

CMN-91 Compact Video and Audio Monitor ... - Biznine.com

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?