00214EN Rev.05 - CytoFAST Elite - Wolf Laboratories
00214EN Rev.05 - CytoFAST Elite - Wolf Laboratories
00214EN Rev.05 - CytoFAST Elite - Wolf Laboratories
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
a D:GROUP company<br />
2.C ELECTRIC/GAS CONNECTIONS and INSTALLATION OF THE WORK SURFACE<br />
The electrical connection of the <strong>CytoFAST</strong> Biohazard cabinet is made by connecting the power cable located<br />
on the upper of the right side of the cabinet to a suitable power point (see technical table) . When the cabinet<br />
is connected, the green light on the control panel switches on (see chapter 4E).<br />
If stipulated by local legislation, insert upstream of the power line an automatic protection overload switch<br />
provided with a differential relay, with a rated switching voltage no greater than 30 mA.<br />
The right side of the cabinet is also provided with two gas/vacuum intakes with manual taps one of which is<br />
fitted with an electrovalve.<br />
The connection with the two gas/vacuum intakes is made according to the type of connection: town gas or<br />
industrial gas (air, vacuum, nitrogen, etc.).<br />
The cabinet must be connected by qualified staff to the town gas mains through an approved conduit for<br />
safety reasons.;<br />
For the installation of the work surface, proceed as follows:<br />
- remove the protective paper from the work surface resting against the back of the cabinet, taking care<br />
not to scratch its surface,<br />
- open the safety front window,<br />
- clean the work surface with a damp cloth soaked in alcohol or soapy water or with a commonly available<br />
product designed for stainless steel,<br />
- place the table in the work chamber, allowing the back to slide on the chamber's supporting bases up to<br />
its bottom wall<br />
- close the safety front window<br />
Note: the plug of the supply cable of the cabinet has the function of “main switch”, therefore the<br />
operator has to access easily to it also after the installation of the cabinet.<br />
<strong>00214EN</strong> <strong>Rev.05</strong> – 12/2011 5