Spicer Tandem Drive Axles Service Manual
Spicer Tandem Drive Axles Service Manual
Spicer Tandem Drive Axles Service Manual
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Endplay Procedure<br />
Check Input Shaft Endplay (Forward Axle)<br />
Note: Before disassembling the power divider, measure and<br />
record input shaft endplay.<br />
1. Position dial indicator at yoke end of input shaft.<br />
2. Push in on input shaft and zero the dial indicator.<br />
3. Using a pry bar, move input shaft axially and measure/record<br />
endplay.<br />
Adjustment<br />
Correct endplay for a new assembly is 0.001" to 0.005". See<br />
the "Input Shaft Endplay" procedure in the "Power Divider<br />
Assembly" section for proper endplay adjustment procedure.<br />
7<br />
Inspection<br />
Check Output Shaft Endplay (Forward Axle)<br />
1. Position dial indicator at yoke end of output shaft.<br />
2. Push in on output shaft and zero the dial indicator.<br />
3. Using a pry bar, move output shaft axially and measure/record<br />
endplay.<br />
Adjustment<br />
Correct endplay for a new assembly is 0.001" to 0.045". The<br />
maximum endplay for a used assembly is no more than<br />
0.045". If endplay is incorrect, contact Dana.