Spicer Tandem Drive Axles Service Manual
Spicer Tandem Drive Axles Service Manual
Spicer Tandem Drive Axles Service Manual
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Manifold Assembly<br />
17<br />
1. Install the manifold assembly into the output side<br />
gear bore in the carrier. Make sure the barbed nipple<br />
is lined up with the opening in the carrier casting.<br />
1 - Barbed Nipple<br />
2. Install the hose clamp on the hose, push the hose<br />
onto the barbed fitting and slide the clamp over the<br />
barbed nipple.<br />
3. Route the suction end of the hose through the holes<br />
in the carrier casting to the bottom of the carrier.<br />
4. Fully press the manifold assembly into position.<br />
Note: Use care when pressing the manifold assembly to avoid<br />
damaging the seals and barbed nipple. Do not overpress<br />
plastic.<br />
1<br />
Power Divider<br />
Note: For non-pump manifold installation, it is important to<br />
line up the oil inlet path hole in the manifold with the oil<br />
path opening in the carrier manifold casting.<br />
1 - Manifold Oil Inlet Hole<br />
5. Attach the suction screen to the end of the hose.<br />
If the unit does not have a pump, go to the Power Divider<br />
Assembly section.<br />
If the unit contains a pump, go to the Pump Assembly section.<br />
1
Change language