Spicer Tandem Drive Axles Service Manual
Spicer Tandem Drive Axles Service Manual
Spicer Tandem Drive Axles Service Manual
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
21<br />
12. Assemble the sliding clutch, shift fork and fork<br />
spring to the input shaft and install assembly into<br />
carrier. Make sure that the shift fork rod is piloted in<br />
the carrier bore.<br />
IMPORTANT<br />
Before installing input cover, inspect and thoroughly clean<br />
mating surfaces using an appropriate solvent and clean<br />
rag.<br />
Note: Completely remove all old gasket material prior to<br />
applying new Loctite.<br />
13. Apply a bead of Loctite 518 to the carrier surface as<br />
shown in the illustration.<br />
190 Cover<br />
170 Cover<br />
Power Divider<br />
14. Install input cover and capscrews. Torque to the<br />
proper specifications. See the Torque Chart on page<br />
D-1. Tighten fasteners in a criss cross pattern.<br />
15. Install input shaft bearing adjuster, adjust inward<br />
until snug against the bearing cone.<br />
Input Shaft Endplay<br />
16. Back off input bearing cage one notch and check<br />
endplay. Endplay should be between 0.001" to 0.005"<br />
(0.03 to 0.13 mm). Rotate cage in or out to get<br />
proper setting.<br />
1 - One Notch<br />
1
Change language