RM2235 Manual PDF - University of Utah
RM2235 Manual PDF - University of Utah
RM2235 Manual PDF - University of Utah
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
6. Optional accessories<br />
6.3.3 Knife holder N/NZ<br />
42<br />
The knife holders N and NZ are appropriate for standard steel and tungsten carbide knives,<br />
pr<strong>of</strong>ile c and d, up to 16 cm long. The integrated height adjustment feature allows you to also<br />
use knives that have been resharpened numerous times.<br />
Mounting the knife support bar<br />
Push knife guard (8) to the center.<br />
Set the knife support bar (46) onto the height adjustment screws (not visible)<br />
in the position shown. The flat ends <strong>of</strong> the height adjustment screws<br />
must be located in the slots at each end <strong>of</strong> the knife support bar.<br />
Knife holder N<br />
For holding conventional<br />
knives up to 16 cm in<br />
length.<br />
49<br />
8<br />
Enlarged detail:<br />
Knife inserted and<br />
height-adjusted<br />
Prior to inserting the knife, both knife holder and knife holder base<br />
must have been installed on the instrument!<br />
48<br />
49<br />
39<br />
46<br />
47<br />
Knife holder NZ<br />
For holding conventional and hard<br />
metal knives up to 16 cm in length.<br />
Knife pressure plate (56) for extreme<br />
stability and full utilization <strong>of</strong> the<br />
knife blade.<br />
56<br />
Fig. 41<br />
Instruction manual V 1.4 – 02/2010