Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Removing/Replacing Face Tanner<br />
Lamp<br />
After opening the canopy acrylic, replace<br />
the face tanner lamp as follows:<br />
1. The face tanner glass is held in place<br />
by two metal brackets. Support the face<br />
tanner glass with your hand while unscrewing<br />
the two screws on one of the<br />
brackets. The face tanner glass will slip<br />
out of the other bracket.<br />
2. The lamp can now be exchanged. Simply<br />
pull the face tanner lamp toward you<br />
to remove it from the socket. Install the<br />
new lamp, using a clean cloth or paper<br />
towel, by inserting it into the lamp socket.<br />
Ensure that the lamp is fi rmly seated<br />
in the lamp socket.<br />
Note! Never take hold of the lamp such that<br />
your fi ngers are in contact with the lamp<br />
glass. Finger oils will greatly reduce the<br />
lamp’s operational life.<br />
3. Slide the face tanner glass into the<br />
bracket attached to the <strong>bed</strong> and lock it<br />
in place with the other bracket and two<br />
screws.<br />
46 - Ultimate Envy 434 Assembly and User Manual<br />
DANGER<br />
Unfi ltered light from face tanner<br />
can cause severe burns.<br />
Never turn sun<strong>bed</strong> on while face<br />
tanner is disassembled or when<br />
glass fi lters are removed.<br />
Immediately discontinue use of<br />
this equipment if face tanner glass<br />
is broken or any unfi ltered light<br />
can be seen escaping face tanner<br />
assembly.<br />
30063-01A