user manual - Tanning-bed-parts.com

More documents

Recommendations

Info

ISSUE RESOLUTION My bed is connected to a T-Max® remote system but I am having trouble getting into “parameter” mode My bed, connected to a T- Max® Manager, did not display “dL” but does indicate: “0” a tanning time and the lamps have come on a tanning time but the lamps have not come on When auto-addressing the fi rst bed does not register an “id” My salon suffers frequent, short power outages and clients complain about losing session time 48 - Ultimate Envy 434 Assembly and User Manual You have probably attempted to connect your sunbed to the remote system already. Disconnect the remote plug(s) from the ports at the back of the sunbed, wait 90 seconds and try again. 1. Remote device has not been set. 2. The sunbed has not been connected to the remote system, see Remote Connections. 1. Delay time of T-Max® Manager has not been set. 2. Delay time has expired and session has begun. Auto start function of T-Max® Manager has been turned off. Press the START/TIME button to turn on lamps. When using the auto address feature of the T-Max® Manager you must wait 10 seconds from the time you start the auto address function before addressing the fi rst bed. If you have a T-Max® Manager, changing parameter 23 from “0” to “1” will allow the tanning bed to remember how much time was left when power goes out and resume its session after power is restored. See Parameters. 30063-01A
30063-01A Notes: Ultimate Envy 434 Assembly and User Manual - 49
Page 1 and 2: user manual 30063-01A
Page 3 and 4: 30063-01A Thank you for purchasing
Page 5 and 6: 30063-01A Rayonnement ultraviolet.
Page 7 and 8: 30063-01A Disassembly Your new tann
Page 9 and 10: 30063-01A Tucked inside the aluminu
Page 11 and 12: 30063-01A The body fan is held in p
Page 13 and 14: 30063-01A The front cross member is
Page 15 and 16: 30063-01A Close the canopy and rein
Page 17 and 18: 30063-01A On the back of the canopy
Page 19 and 20: 30063-01A Remove the (16) #10-32x1/
Page 21 and 22: 30063-01A Assembly Place the pedest
Page 23 and 24: 30063-01A Slip the rear cross membe
Page 25 and 26: 30063-01A Slide the canopy frame in
Page 27 and 28: 30063-01A If you retightened the sc
Page 29 and 30: 30063-01A Install the front cross m
Page 31 and 32: 30063-01A Slip the USB extension ca
Page 33 and 34: 30063-01A Slip the “hooks” at t
Page 35 and 36: 30063-01A Electrical Connections Th
Page 37 and 38: 30063-01A Remote Connections Your s
Page 39 and 40: 30063-01A Scenario 4 - T-Max® Mana
Page 41 and 42: 30063-01A Operation Before You Tan
Page 43 and 44: 30063-01A The Tanning Session (Oper
Page 45 and 46: 30063-01A Opening / Replacing Acryl
Page 47: 30063-01A Sunbed not tanning ISSUE
Page 51 and 52: 30063-01A Parameter Function Defaul

user manual - Tanning-bed-parts.com

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?