CUTSKILL® C-35A - Victor Technologies

More documents

Recommendations

Info

This Page Left Blank Manual 0-4698 3-2 Installation
SECTION 4: OPERATION 4.01 Front Control Panel Overheating Indicator "On / Off" Switch AC Power Indicator Air Vents Work Lead Connection A. Indicator Lamp Power Indicator I 14 16 <strong>35A</strong> O Air Error Indicator Torch Switch Latch Indicator 115VAC 230VAC Art # A-04386 10 10 11 12 13 14 15 12 8 16 17 18 19 20 21 22 23 24 25 20 18 A Torch Switch Latch Button Air Set Button Current Control Knob Torch Connection Lights when primary power switch is turned on. TEMPERATURE Indicator Indicator is normally OFF. Indicator is ON when internal temperature exceeds normal limits. Air Error Indicator This indicator lights and is accompanied by an intermittent audible tone when there is not enough air pressure to operate the power supply. Indicator is normally off. NOTE It is possible to have enough air pressure to operate the power supply but not enough air flow to operate the torch. Torch Switch Latch Indicator This indicator lights when the Torch Switch Latch Button has been pressed for continuous cutting. B. Buttons Torch Switch Latch Button For continuous cutting performance. Depress this button ( turn “On” ) while cutting with the torch. Release the torch trigger and the torch will continue to cut without depressing the torch trigger. Air Set Button To adjust air pressure and to cool down heated torch. Art # A-04503 Air will flow from gap next to shield cup. C. Main Current Control Knob To adjust cutting current. Turning clockwise increases the cutting current and counter clockwise decreases the cutting current. Art # A-04387 Operation 4-1 Manual 0-4698 15 D. Primary Power Switch, ON / OFF 10 20 25 35 30 A The power switch is located on the front panel. Placing the primary power switch to the “ON” position energizes the power source and activates the Power Indicator.
Page 1: C-35A CUTSKILL ® PLASMA CUTTING SY
Page 5 and 6: TABLE OF CONTENTS SECTION 1: GENERA
Page 7 and 8: SECTION 1: GENERAL INFORMATION 1.01
Page 9 and 10: THAT HAVE HELD HAZARDOUS SUBSTANCES
Page 11 and 12: 1.05 Statement of Warranty LIMITED
Page 13 and 14: SECTION 2: INTRODUCTION General Inf
Page 15: 3.01 Site Selection SECTION 3: INST
Page 19 and 20: E. Typical Cutting Speeds Cutting s
Page 21 and 22: 5.01 General Maintenance SECTION 5:
Page 23 and 24: SECTION 6: TROUBLESHOOTING WARNING
Page 25 and 26: 6.03 Control PCB Indicators 1. Turn
Page 27 and 28: A. Diode Testing Basics WARNING Dis
Page 29 and 30: B. Component Tests WARNING Disconne
Page 31 and 32: General Information SECTION 7: PART
Page 33 and 34: 21 26 22 11 16 17 15 12 24 Art # A-
Page 35 and 36: 5 6 4 1 3 7 Manual 0-4698 7-5 PARTS
Page 37 and 38: Appendix 1: Operating Sequence, Blo
Page 39 and 40: Appendix 3: Microchip Pin-Out CPU S
Page 41 and 42: No.40270601 AIR ERROR 218 VAC LD2 E
Page 43 and 44: No.40270601 AIR ERROR 218 VAC LD2 E
Page 45 and 46: GLOBAL CUSTOMER SERVICE CONTACT INF

CUTSKILL® C-35A - Victor Technologies

Create successful ePaper yourself

Delete template?

Save as template?