CUTSKILL® C-35A - Victor Technologies

More documents

Recommendations

Info

This Page Left Blank Operation 4-4 Manual 0-4698
5.01 General Maintenance SECTION 5: MAINTENANCE Warning! Disconnect input power before maintaining. Visual check of regulator and pressure Visually inspect the torch body tip, electrode and shield cup Replace all broken parts Art # A-04929 Gas and air lines Each Use Weekly Visually inspect the cables and leads. Replace as needed 3 Months 6 Months Visually check and Carefully clean the interior Visual check of torch tip and electrode Clean exterior of power supply Maintain more often if used under severe conditions Maintenance 5-1 Manual 0-4698
Page 1: C-35A CUTSKILL ® PLASMA CUTTING SY
Page 5 and 6: TABLE OF CONTENTS SECTION 1: GENERA
Page 7 and 8: SECTION 1: GENERAL INFORMATION 1.01
Page 9 and 10: THAT HAVE HELD HAZARDOUS SUBSTANCES
Page 11 and 12: 1.05 Statement of Warranty LIMITED
Page 13 and 14: SECTION 2: INTRODUCTION General Inf
Page 15 and 16: 3.01 Site Selection SECTION 3: INST
Page 17 and 18: SECTION 4: OPERATION 4.01 Front Con
Page 19: E. Typical Cutting Speeds Cutting s
Page 23 and 24: SECTION 6: TROUBLESHOOTING WARNING
Page 25 and 26: 6.03 Control PCB Indicators 1. Turn
Page 27 and 28: A. Diode Testing Basics WARNING Dis
Page 29 and 30: B. Component Tests WARNING Disconne
Page 31 and 32: General Information SECTION 7: PART
Page 33 and 34: 21 26 22 11 16 17 15 12 24 Art # A-
Page 35 and 36: 5 6 4 1 3 7 Manual 0-4698 7-5 PARTS
Page 37 and 38: Appendix 1: Operating Sequence, Blo
Page 39 and 40: Appendix 3: Microchip Pin-Out CPU S
Page 41 and 42: No.40270601 AIR ERROR 218 VAC LD2 E
Page 43 and 44: No.40270601 AIR ERROR 218 VAC LD2 E
Page 45 and 46: GLOBAL CUSTOMER SERVICE CONTACT INF

CUTSKILL® C-35A - Victor Technologies

Create successful ePaper yourself

Delete template?

Save as template?