Installation Instructions Stationary Weighpad_ELWC - WIM

2.2 Installation Materials
Item Quantity Description
1 1 per
frame
2 Per site
plans
3 Per site
plans
4 Per site
plans
Approximately 7 gallons of two-part filled epoxy.
Recommended brand is “E–Bond G–100,” shipped in
2.7 gallon cans.
Galvanized steel conduit as per site plan, for cables and
drain water. If the conduit has to be installed in the road
surface, choose a diameter of 1-½” or 2" for crush
strength. If there is a possibility of installing the conduit
below the frame and road surface, choose a diameter of
2" to 3", for maximum ease of cable installation and to
avoid future maintenance issues. For the drain water,
PVC pipe can be used if crush strength is not a concern.
Elbows, galvanized, diameter matching item #2.
Conduit grounding bushings for weighpad frames and all
junction boxes.
5 #8 solid copper ground wire.
6 Per site
plans
7 80lb per
frame
Pullboxes
Portland cement, without rocks.
8 Marking tape (length depending on ditch length). The
plastic tape with red and white stripes is inserted before
closing the ditches. It is used as a warning in the event
of future earthmoving operations.
9 3 per
frame
10 1 oz. per
frame
Caulk tubes of silicone sealer.
Anti-seize grease
11 1 Roll of 2" duct tape
12 4 Parts to construct frame leveling aids. These consist of:
3' section of 2x4
2 6" sections of ½-20 threaded rod
4 ½-20 nuts
4 ½ flat washers
M&E Vendor Documents
6
Control Systems
Section 9.11.3
Page 10 of 36