Installation Instructions Stationary Weighpad_ELWC - WIM

More documents

Recommendations

Info

Figure 3 - Frame Illustrated Parts Breakdown 8 M&E Vendor Documents Control Systems Section 9.11.3 Page 12 of 36
3. INSTALLATION PROCEDURE The following jobs have to be performed: ! Ensure sufficient protection of the job site. ! With chalk and marking paint, mark the exact installation points for frames and induction loops as well as for drain pipes and cable conduits. See site-specific diagrams provided by IRD-PAT Traffic. If the conduits and drains were precast into the concrete slab, verify placement accurately. The drains must be centered under the weighpad in the traffic direction. Observe squareness to the traffic direction. Figure 4 - Laying out Site 123-429-901-120.JPG 9 M&E Vendor Documents Control Systems Section 9.11.3 Page 13 of 36
Page 1 and 2: Manual, Weighpad and Frame Installa
Page 3 and 4: TABLE OF CONTENTS 1. GENERAL INFORM
Page 5 and 6: 1. GENERAL INFORMATION The stationa
Page 7 and 8: Trucks, when passing the measuring
Page 9 and 10: Power Tools: Item Quantity Descript
Page 11: 13 1 Spray paint (epoxy paint) with
Page 15 and 16: Figure 6 - Cutting Frame Recess 123
Page 17 and 18: ! Check depth of the cutout by inse
Page 19 and 20: ! For inline weighpads that are inl
Page 21 and 22: ” Do not use epoxy remaining on t
Page 23 and 24: ! Insert anchors down as far as pos
Page 25 and 26: ! At each mounting stud, measure ne
Page 27 and 28: ! Set weighpad onto two wooden piec
Page 29 and 30: 4. APPENDIX E-Bond G-100 Epoxy 25 E
Page 31 and 32: 27 Ebond G100 Page3.jpg M&E Vendor
Page 33 and 34: 29 Ebond G100 Page5.jpg M&E Vendor
Page 35 and 36: 5. APPENDIX SITE SURVEY FORM Wim Si

Installation Instructions Stationary Weighpad_ELWC - WIM

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?