Installation Instructions Stationary Weighpad_ELWC - WIM
Installation Instructions Stationary Weighpad_ELWC - WIM
Installation Instructions Stationary Weighpad_ELWC - WIM
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
! Apply the epoxy with a wire brush to vertical edges of the frame recess to obtain<br />
maximum bonding and eliminate air pockets. Epoxy will not adhere otherwise<br />
and can cause early loosening of the frame.<br />
! Immediately afterwards press the frame into the epoxy and insert the anchors.<br />
Remove epoxy overflowing into the frame immediately. Make sure the frame<br />
rests completely on epoxy. If pockets of air are suspected underneath the<br />
frame, immediately lift frame and fill with more epoxy.<br />
The epoxy may not fill up to the road surface. It must completely fill up to the<br />
top level of the steel frame.<br />
Figure 15 - Removing Excess Epoxy 123-429-901-000.jpg<br />
18<br />
M&E Vendor Documents<br />
Control Systems<br />
Section 9.11.3<br />
Page 22 of 36