WO 100 2 - ESAB

GB
5.1.2 File manager
This view is used to save, copy, clear and verify weld programs.
S Save weld program
To save a weld program, select where you want the program to be saved, either
on the control unit (User defined programs) or on a USB memory device
(External memory).
Specify a file name and click the ’Save weld program’ button using the knob.
S Copy weld program to another area
Depending on which work area is active, it is possible to copy the contents of
one area to another area by clicking the ’Copy this wld program to design area’
button or ’Copy this weld program to weld area’ button.
S Clear, reset weld program
If you want to begin a brand new weld program, click the ’Clear weld area’
button or ’Clear design area’ button.
S Verify
This function is used to check whether the weld program in the current work area
fulfils the system’s requirements as follows:
S A tool is selected for the weld program.
S The connected tool is the same as the one the program is designed for (only
applies to weld area).
S The program has at least two sectors (start and stop sector).
S The final sector in the program is a stop sector (the welding current is zero).
S Selected tube diameter is supported by the selected tool.
S The welding parameters in each sector are within the limits (min. and max.
values) for the selected tool.
5.1.3 Information
Used to enter information about the weld program. This information does not affect
the welding process, but is an aid for describing the program in words.
bi16d1ea
- 16 -