WO 100 2 - ESAB

GB
Proceed as follows:
S Connect a USB memory device to the panel’s USB terminal, where the
”MechTIG_Tools.xml” file is at the very root of the file structure.
S Move to the ”Load tools from usb--memory” button using the arrow keys.
S Press the knob and confirm using ”Yes” to invalidate all the changes made to the
tool.
Clear or reset all parameters in the tool area by moving to the ”Clear tooll” button
and pressing the knob. Confirm using ”Yes” to invalidate any changes made in the
tool area.
To save all your tools to a USB memory device:
S Connect a USB memory device to the panel’s USB terminal.
S Move to the ”Save tools to usb--memory” button and press the knob.
S Confirm using ”Yes” to save the tools and overwrite any tools stored on the USB
memory device.
5.7.2 Edit settings
This view is used once you have loaded a tool or when you want to create a brand
new tool. Here you can view and edit all parameter values for a tool.
The ”General settings” field contains general settings for the tool, while the
”Parameter limits” field defines the highest and lowest values for a parameter.
For min. values the value 0 means that the minimum value has not been set, while
for max. values 65535 means that the maximum value has not been set. (In some
instances, where decimals are used, 655,30 or 6553,5 may indicate not set).
5.7.3 Edit motor data
In this view, you can view and edit specific motor settings. There are motor settings
for each motor (rotation, wire feed, weaving and AVC). There are currently three
parameters per motor. The parameters are ”Setting parameter”, ”Scalefactor
position” (”numerator” and ”denominator”) and ”Scalefactor speed” (”numerator” and
”denominator”).
bi16d1ea
- 29 -