Getting Started - ASCO Numatics

G2-2 Series Interbus-S Quick Start Manual
M23 Interbus-S Communication Module
Upon power up, the LEDs indicate the status of the unit. The Power Module of the G2-2 Interbus-S node has
four LEDs; two for internal fuse integrity and two for Aux. Power status. The Communication module also
has four status LEDs which are described below.
LED Name
TR
Color Status Description
(Transmit /
Receive)
RD
Green ON Active when PCP communication is made over the Interbus-S Network
(Remote Bus
Disable)
Red ON On when the outgoing remote bus is switched off.
BA
(Bus Active)
Green ON Bus is active.
CC
(Cable Check)
+24V/F1
(VLV/OUT)
+24V/F2
(NODE/IN)
Green ON The cable connection is good, and the Interbus-S Master is not in reset
Green
Green Red
Green
Green Red
OFF No DC Power present at +24V VLV / OUT pin on Aux. Power connector.
ON DC Power applied to +24V VLV / OUT pin on Aux. Power Connector.
OFF
Internal fuse F1 is OK (valid only when power is applied to
+24V VLV / OUT pin on Aux. Power connector).
ON
Internal fuse F1 is open; No power is internally provided to valves or
outputs. Communication NOT affected.
OFF No DC Power present at +24V NODE / IN pin on Aux. Power connector.
ON DC Power applied to+24V NODE / IN pin on Aux. Power connector.
OFF
Internal fuse F2 is OK (valid only when power is applied to
+24V NODE / IN pin on Aux. Power connector.
ON
Internal fuse F2 is open; No power is internally provided to node
electronics or inputs. Communication Node will not function.
TDG22ISQS3-0 5/07
Subject to change without notice
www.numatics.com/fieldbus
Page 15