Control Units - Siemens

Parameters
Introduction to Parameters
Data type
Quick Comm
Active
The data types available are shown in the table below.
Table 1-1 Available data types
Notation Meaning
Unsigned8 (U8) 8-bit unsigned
Unsigned16 (U16) 16-bit unsigned
Unsigned32 (U32) 32-bit unsigned
Integer16 (I16) 16-bit integer
Integer32 (I32) 32-bit integer
Floating Point (Float) Floating point
The information of the data types for binector and connector inputs can be composed
of two specifications (discreated by a slash):
• First specification
data type of the parameter
• Second specification
data type of the signal source preferably to be connected (binector or connector
output)
Indicates whether or not (Yes or No) a parameter can only be changed during
quick commissioning, i.e. when P0010 (parameter groups for commissioning) is
set to 1 (quick commissioning).
• YES changes to the parameter values take effective immediately after
they have been entered.
• No the “P” button on the Operator Panel must be pressed before the
changes take effect.
1-10 © Siemens AG 2008 All Rights Reserved
SINAMICS G120 Control Units CU240E/S, Edition 07/2008