Control Units - Siemens

0054.0...15 CO/BO: Act. control word 1 / Act CtrlWd1
Access level: 3 P-Group: Commands Data type: Unsigned16
Unit: - Calculated: - Data set: -
© Siemens AG 2008 All Rights Reserved
SINAMICS G120 Control Units CU240E/S, Edition 07/2008
Parameters
List of Parameters
Description: Displays first control word of inverter (in bit format) and can be used to diagnose which commands are active.
Bit field: Bit Signal name 1 signal 0 signal FP
00 ON/OFF1 Yes No -
01 OFF2: Electrical stop No Yes -
02 OFF3: Fast stop No Yes -
03 Pulse enable Yes No -
04 RFG enable Yes No -
05 RFG start Yes No -
06 Setpoint enable Yes No -
07 Fault acknowledge Yes No -
08 JOG right Yes No -
09 JOG left Yes No -
10 Control from PLC Yes No -
11 Reverse (setpoint inversion) Yes No -
13 Motor potentiometer MOP up Yes No -
14 Motor potentiometer MOP down Yes No -
15 CDS Bit 0 (Hand/Auto) Yes No -
Notice: r0054 is identical to r2036 if USS is selected as command source via P0700 or P0719.
r0055.0...15 CO/BO: Act. control word 2 / Act CtrlWd2
PM240 Access level: 3 P-Group: Commands Data type: Unsigned16
Unit: - Calculated: - Data set: -
Description: Displays additional control word of inverter (in bit format) and can be used to diagnose which commands are active.
Bit field: Bit Signal name 1 signal 0 signal FP
00 Fixed frequency Bit 0 Yes No -
01 Fixed frequency Bit 1 Yes No -
02 Fixed frequency Bit 2 Yes No -
03 Fixed frequency Bit 3 Yes No -
04 Drive Dataset (DDS) Bit 0 Yes No -
05 Drive Dataset (DDS) Bit 1 Yes No -
08 Enable PID Yes No -
09 Enable DC brake Yes No -
11 Enable Droop Yes No -
12 Torque control Yes No -
13 External fault 1 No Yes -
15 Command Dataset (CDS) Bit 1 Yes No -
Notice: r0055 is identical to r2037 if USS is selected as command source via P0700 or P0719.
1-25