Software Manual - Galaxy Control Systems

Chapter 2 Overview
Software Manual |System Galaxy 7
Chapter 2 contains the System Installation Procedure and a brief highlight of each step.
• System Installation Procedure: an organized list of the overall system installation and setup steps.
It references chapters in the Software Manual, as well as other manuals and artifacts that contain
vital instructions not found in this manual.
• Description of Installation Steps The following sections provide a brief description of each
step for the reader’s convenience with references to location of detailed information.
System Installation Procedure
Part Steps Artifacts and References
A Develop a Site Plan Use blueprints and diagrams of jobsite
B Purchase Hardware and Software N/A
C Install Hardware see System Galaxy Hardware Manual
D
Preparing for Software Installation (Procedure)
< Instructions/Templates & Diagrams Included >
E Install Software
Chapter 3 of this manual
Chapter 4 of this manual; and the
Software Installation document (found
on the CD)
F Registration the system and workstation Chapter 5 of this manual
G Add a Basic Loop Chapter 5 of this manual
H Auto-Connect to Loop Chapter 5 of this manual
I Load Flash Chapter 5 of this manual
J Burn Flash Chapter 5 of this manual
K loop diagnostics controller reset Chapter 5 of this manual
L Load Data Chapter 5 of this manual
M Create a Test Card with Unlimited Access Chapter 5 of this manual
N Configure Hardware/Software Options Chapter 3, 7, 8, and 9 of this manual
O Load Data Chapter 5 of this manual
P Add Additional Loops as Needed: repeating steps G thru O for each Additional Loop
Q Set Up System Operator Permissions Chapter 10 of this manual
R Set Up Automatic Database Backups Chapter 21 of this manual
System Installation Procedure | Chapter 2-2