Software Manual - Galaxy Control Systems

I: Load Flash
Software Manual |System Galaxy 7
Loading Flash is covered in Chapter 5. Loading flash is recommended any time the CPU boards
have a different version of flash then the s28 file in the Software Flash directory. Hardware flash
must match the software flash – validation is recommended.
J: Burn Flash
It is necessary to burn flash into memory. This is covered in Chapter 5.
K: Controller Reset
It may be recommended to force a cold reset from the Loop Diagnostics screen. See Chapter 5.
L: Loading Data
This load session sends the loop programming done in (step G) to the controllers. See Chapter 5.
M: Create a TEST CARD
It is a good practice to create a test card and walk-test the loop. Chapter 5 covers this in detail
N: Configuring Software options
The site setup information collected during Chapter 3 will be used to setup the software
programming. If you did not complete the collection of setup info, use the Templates in Chapter 3
to do this (also see Appendix A – copy as needed). See the 600-Series Interface manual for
templates and instructions relating to setting up a 600 Loop/Cluster and boards.
O: Load Data (not flash)
Once Software Setup is complete, installer will Load Data again. This is covered in Chapter 5.
P: Repeat steps G thru O as needed
Add additional loops as needed.
Q: Setup System Operators
Add System Operators with permissions/filters as needed. See Chapter 10 for details.
R: Setup Automatic DB Backups
Add additional loops as needed. Chapter 21 of this manual provides information on setting up
backups. Also see the Section on the Galaxy Service Manager utility, which includes an interface
to creating scheduled backups for a customer using MSDE 2000.
System Installation Procedure | Chapter 2-6