user´s manual fixturlaser xa geometry

STRAIGHTNESS
MEASUREMENT
INTRODUCTION
In the Straightness Measurement
program, straightness can be measured
in two axes. The laser beam is used as
reference and the deviation in distance
between the laser beam and the
measurement object is measured in two
or more positions, with the use of the
receiver.
MEASUREMENT METHODS
In the Straightness Measurement
program, there are different
measurement methods. Measurement
method is selected in the measurement
point window.
Standard Straightness
The laser beam is set roughly
parallel to a surface or an
object. Two points are used
as references.
Straightness with the
Clock method as reference
The laser beam is set roughly
parallel to a centre line. Two
points are used as references.
The receiver is rotated 180
degrees in each measurement
point to find the centre of the
measurement object.
Fixturlaser XA Geometry Manual 4.1