Press Matcher Web RIP Settings - image2output - Support
Press Matcher Web RIP Settings - image2output - Support
Press Matcher Web RIP Settings - image2output - Support
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
WEB«<br />
http://www.<strong>image2output</strong>.com<br />
EFI Fiery <strong>RIP</strong><br />
Internal Printer Calibration<br />
Make sure the correct output profile is selected.<br />
If the measured densities are considerably higher than the target<br />
densities, it may be a good idea to correct the output profile. This allows<br />
a larger portion of the printer’s color gamut to be used.<br />
Note down the measured values and proceed as described below.<br />
12.Close the dialogs by clicking DONE, APPLY and DONE.<br />
Correct Output Profile<br />
We recommend to correct the target density values (D-Max) in Fiery’s<br />
output profile, if considerably higher values were measured during calibration.<br />
You should set the target values a little lower than the measured<br />
values to allow for possible color drifts that may occur over time.<br />
Example:<br />
Target value in output profile: 1.60<br />
Measured value: 1.80<br />
New target value: 1.75<br />
1. Select DEVICE CENTER | RESOURCES | PROFILES.<br />
2. Open the list of OUTPUT PROFILES.<br />
3. Right-click the output profile you have created, e.g. ‘ORIS Pearl<br />
Digital 170 gsm’, and select EDIT PROFILE.<br />
ORIS <strong>Press</strong> <strong>Matcher</strong>⁄⁄<strong>Web</strong> Version 1.1 Fiery and Creo <strong>RIP</strong> <strong>Settings</strong> 2-17<br />
Image2Output Limited Unit 19 IO Centre Hearle Way Hatfield Business Park Hatfield Herts AL10 9EW<br />
Tel: +44 (0)1707 282 710 Fax: +44 (0)1707 269 764 sales@<strong>image2output</strong>.com