Distributed / AS-Interface/ Logic Controller ... - Schneider Electric
Distributed / AS-Interface/ Logic Controller ... - Schneider Electric
Distributed / AS-Interface/ Logic Controller ... - Schneider Electric
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Adding an<br />
Emergency-<br />
Stop<br />
6 The following dialog box will<br />
appear if you place a forced<br />
Emergency-off in the area.<br />
In the Name field, enter a<br />
unique name, which will help<br />
you to find the device reliably<br />
and without confusion (all<br />
device names should be<br />
selected on this basis).<br />
Next, assign an Address to<br />
the device; only the addresses<br />
you entered as safe slaves<br />
when configuring the motor<br />
and have not yet used will<br />
appear.<br />
We use Local<br />
acknowledgement. In our<br />
example we use the <strong>AS</strong>-<br />
<strong>Interface</strong> Slave address 5<br />
which depends to one of the<br />
XALD Pushbuttons. The Bit<br />
address is IN-2.<br />
Note: If you activate the Start-up<br />
test, when the power supply is<br />
restored, the device specified<br />
must be forced (triggered) in order<br />
to be able to acknowledge the<br />
monitor.<br />
Selecting<br />
the Start<br />
Condition<br />
Confirm with OK.<br />
7 Once the switches and safety<br />
guard monitoring have been<br />
added to the configuration, the<br />
start device is added.<br />
In the example we use<br />
Automatic Start.<br />
Confirm with OK.<br />
Optimized <strong>AS</strong>-<strong>Interface</strong> M238 <strong>Schneider</strong> <strong>Electric</strong> 95
Change language