Distributed / AS-Interface/ Logic Controller ... - Schneider Electric

Select the
tab Address
assignment
Fill out the
node types
safe and
standard
3 On the Information about
bus tab, enter the safe and
standard slaves you are using.
If you are using standard
slaves for acknowledgement
and error reset, you will need
to enter them here.
The slave addresses of
Preventa inputs are 2, 3 and
23.
The safety monitors for which
addresses 1 and 24 have been
reserved are not entered here.
Select the
Diagnosis /
Service tab
Fill out the
Monitor base
address
4 Enter the address of the safety
monitor on the last tab,
Diagnosis / Service.
The address 24 is used for the
safety monitor of the Remote
cabinet.
Confirm with OK.
Optimized AS-Interface M238 Schneider Electric 98