TH-V70R[B] revision - JVC

Getting Started
Connecting the FM and AM (MW) antennas
• Make sure the antenna conductors do not touch any other terminals, connecting cords, and power cords. This could cause
poor reception.
7 AM (MW) loop antenna
Setting up AM (MW) loop antenna
Attach the AM (MW) loop to its base by snapping the tabs on the loop
into the slot in the base.
Connecting AM (MW) loop antenna
1
Press and hold the
terminal clamp.
2
Insert the antenna cord.
If the antenna cord is covered with vinyl, remove the
vinyl by twisting it as shown.
Outdoor single vinyl-covered wire (not supplied)
3
Release the finger from
the clamp.
If reception is poor:
Connect an outdoor single vinylcovered
wire to the AM EXT
terminal with keeping the AM
(MW) loop antenna connected.
AM (MW) loop
antenna
Wire
• Turn the loop until you
have the best
reception.
TO SP-PWV70
AUX IN
DIGITAL IN
Center unit
FM 75
R
AM LOOP
L
OPTICAL
ANTENNA
AV
COMPU
LINK
AV
AV OUT
VIDEO OUT
VIDEO
7 FM antenna
COAXIAL
AM EXT
H V
DISP.SET
RGB
Y / C
S-VIDEO
AC IN
Connecting the supplied FM antenna
Extend the supplied FM antenna horizontally.
If reception is poor:
Connect an outdoor FM antenna
with the standard type (coaxial)
connecter.
Outdoor FM antenna
(not supplied)
Outdoor FM antenna cord (not supplied)
NOTES:
• Disconnect the supplied FM Antenna before attaching a 75 Ω coaxial connector (the kind with a round wire going to an outdoor antenna).
• We recommend that you use a coaxial cable to the FM antenna, since it is well-shielded against interference.
11