NETWORK VIDEO RECORDER - Samsung

menu setup
Setting the Network Connection Using Router
J
` To avoid IP address conflict with the NVR's static IP, check followings :
• Setting the NVR with a static IP
- Internet connection : You can connect the NVR to a router which is connected to an PPPoE/Cable modem
or a router in a Local Area Network (LAN) environment.
• Setting the NVR Network
1. Set the in menu of the connected NVR to .
2. Check whether the set IP address is in the static IP range provided by the Broadband Router.
IP, Subnet Mask and Gateway : Consult your network manager.
` Check whether the set IP address is in the static IP range provided by the Broadband Router.
J
` If a DHCP server is configured with starting address (192.168.0.100) and end address (192.168.0.200), you should set the
IP address out of the configured DHCP range (192.168.0.2 ~ 192.168.0.99 and 192.168.0.201 ~ 192.168.0.254).
3. Check the Gateway address and subnet mask are equal to those set in the Broadband Router.
• Setting the DHCP IP Address of the Broadband Router
1. To access the Broadband Router's configurations, open a web browser on the local PC that is connected
to the Broadband Router and enter the router's address (ex : http://192.168.1.1).
2. At this stage, make the local PC's windows network configurations to the below example :
Ex) IP : 192.168.1.2
Subnet Mask : 255.255.255.0
Gateway : 192.168.1.1
M
- Once connected to the Broadband Router, it prompts with password. While entering nothing to the User
Name field, enter "admin" into the password field and press to access the router configurations.
- Access the router's DHCP configuration menu and set its DHCP server activation, and provide the start
and end address.
Set the start address (192.168.0.100) and end address (192.168.0.200).
` Above steps may differ from the router devices depending on the manufacturer.
78_ menu setup