Daf LF.book - Peterbilt Motors Company
Daf LF.book - Peterbilt Motors Company
Daf LF.book - Peterbilt Motors Company
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Inspections and Maintenance<br />
- Do not spray directly onto steering ball joints.<br />
- The power steering fluid reservoir is fitted with a vent. Water may enter the<br />
reservoir via this vent, which will cause damage to the steering gear.<br />
- When cleaning the radiator/intercooler, take care not to damage the fins.<br />
- Do not direct the high-pressure cleaner/steam cleaner jet too long at the<br />
air-conditioning system condenser. As a result of the high temperature, the<br />
pressure in the system will rise too high, which may cause damage to the<br />
system. Parts of the air-conditioning must not be cleaned with the aid of a<br />
high-pressure/steam cleaner as this can cause damage to the seals.<br />
- Make sure that no water can enter the differential and gearbox via the vents.<br />
- Make sure that no water can enter via the reservoir bleed screws of the clutch,<br />
brakes, trailing axle, etc.<br />
- The engine and engine compartments can be cleaned with a high-pressure/<br />
steam cleaner. Avoid spraying directly onto electrical components such as the<br />
fuel system pump units, electronic units the starter motor, alternator,<br />
air-conditioning compressor, headlights, etc.<br />
- Carefully clean the engine encapsulation and its fittings. Remove any spilled oil<br />
and diesel oil to avoid the risk of fire.<br />
- Do not aim the jet of water directly at electrical connections such as connectors,<br />
cable plugs in the vehicle lighting system, etc. Also do not aim the jet at the gear<br />
lever unit.<br />
- When cleaning the vehicle, make sure that no water can enter the air inlet<br />
system via the air intake or its flexible seals.<br />
- When the vehicle has been cleaned, it must be lubricated again with a grease<br />
gun or via the automatic lubrication system. This is important because it<br />
prevents the penetration of moisture and dirt at the various pivot points.<br />
137