Vulkan Lokring MGLD.3000 Product Manual - Schoonover, Inc.

More documents

Recommendations

Info

Multi Gas Leak Detector MGLD.3000 Operating instructions Start Menus Warnings / functions Select leak search mode inactive Warning symbol - blinks while sensor is heated Sensor is heating inactive inactive inactive protected with password Connected to power socket Battery charge status Yellow background Warning/error present: Sensor is heating After heating up the probe (1 - 2 min. depending on special type) the MGLD.3000 is ready to operate and the probe is active. Device ready to operate Probe active The MGLD.3000 provides the option to protect the settings with a user password and is protected with an initial password set at the factory. Press the "lock" pictogram to access the user password query. protected with password Password Select leak search mode inactive Warnings / functions Device ready to operate Probe active inactive inactive inactive protected with password Connected to power socket Battery charge status Entry Enter the correct initial password (123) to remove the lock. 123 Delete the previous character Confirm Cancel Next, the leak search mode opens that was in use before the device was last switched off. BAL_MGLD3000_20101001_en.doc 24-54
Multi Gas Leak Detector MGLD.3000 Operating instructions 4.3.3. Leak search mode Analysis mode Menus Warnings / functions Select leak search mode Check + calibration Device ready to operate Probe active Settings Print out log and save to external data medium Service (device status, password, contact information) unlocked Connected to power socket Battery charge status The leak search mode being used is displayed below the menu bar on the left, the alarm threshold setting is displayed in the center, and the selected gas type is displayed on the right . The MGLD.3000 automatically detects the type of sensor that is connected at the start. The gas type that was most recently selected with this special type is saved and displayed by special type, either in red (hydrogen), blue (refrigerant), or black (CO2) (example above: 5%H2). This and the indicator of the settings are adequate in the other leak search modes "dynamic search mode" and "multipoint mode". The analysis mode is provided for quantitative gas leak detection. Based on the setting, the currently detected concentration or leak rate is displayed as a number with the relevant unit (e.g., ppm for the concentration) and in graphical form as a temporal progression. As the concentration increases the frequency increases and the tone sequence of the acoustic signal becomes shorter. When the threshold boundary is exceeded, a continuous sound is emitted and the screen background and numeric data are colored red. BAL_MGLD3000_20101001_en.doc 25-54
Page 1 and 2: MGLD.3000 OPERATING INSTRUCTIONS 01
Page 3 and 4: Multi Gas Leak Detector MGLD.3000 O
Page 23: Multi Gas Leak Detector MGLD.3000 O
Page 55: Multi Gas Leak Detector MGLD.3000 O

Vulkan Lokring MGLD.3000 Product Manual - Schoonover, Inc.

Create successful ePaper yourself

Delete template?

Save as template?