Solution 4+4 Installation Manual - Securityhelpdesk.com.au

Programming 25
Command 963 - Copy From Programming Key To Control Panel
This command is used to copy data from the programming key to the control panel.
How To Copy The Programming Key Memory To The Control Panel
1. Enter Installer's Programming Mode.
(ie. 1234 followed by the # button).
2. Connect the programming key onto the pins marked PROGRAMMING KEY on the
control panel.
3. Enter command 963 followed by the # button.
Two beeps will be heard and the programming key's data has now been copied to the
control panel.
4. Enter command 960 followed by the # button to exit Installer's Programming
Mode.
5. Disconnect the programming key from the control panel.
How To Copy Programming Key Memory To Control Panel Using Hand Held Programmer
1. Before connecting the hand held programmer to the control panel, make sure that the
switch on the hand held programmer is in the EXT position and that no external
programming key has been plugged onto the hand held programmer.
2. Enter Installer's Programming Mode.
(ie. 1234 followed by the # button).
3. Plug the programming key onto the pins marked EXTERNAL KEY on the hand held
programmer.
4. Enter command 963 followed by the # button.
Two beeps will be heard and the programming keys data will now be copied to the
control panel.
5. Enter command 960 followed by the # button to exit Installer's Programming
Mode.
6. Leave the switch on the hand held programmer in the EXT position and disconnect the
programming key.
Electronics Design and Manufacturing Pty Limited
ISSUE123.DOC