Solution 4+4 Installation Manual - Securityhelpdesk.com.au

Programming 27
Command 965 - Set Up Domestic Dialling Format
Command 965 has been added to make the set up of the domestic dialling format a one step
operation. Refer to page 76 for more information on Domestic Reporting Format.
After Installer's Programming Mode has been accessed, enter command 965 followed by
the # button. This will automatically set the following locations in bold below. No other
locations will be changed when command 965 has been issued.
Location Description Setting
LOCATION 49 Handshake Tone 2 (1400 Hz)
LOCATION 50 Transmission Format 11 (Domestic)
LOCATION 052 – 055 Subscriber ID Number 0, 0, 0, 1 (1 Beep)
LOCATION 104 – 111 Zone 1 2, 0, 0, 0, 0, 3, 0, 1 (Delay-1)
LOCATION 112 - 119 Zone 2 1, 0, 0, 0, 0, 3, 0, 1 (Handover)
LOCATION 120 - 127 Zone 3 1, 0, 0, 0, 0, 3, 0, 1 (Handover)
LOCATION 128 - 135 Zone 4 12, 0, 0, 0, 0, 3, 0, 1 (24 Hour)
LOCATION 152 - 153 Bypass Reports 0, 0 (Not Used)
LOCATION 154 - 155 Trouble Reports 0, 0 (Not Used)
LOCATION 156 - 159 Codepad Duress 0, 0, 0, 0 (Not Used)
LOCATION 160 - 163 Codepad Panic 0, 0, 0, 0 (Not Used)
LOCATION 164 - 167 Access Denied 0, 0, 0, 0 (Not Used)
LOCATION 168 - 171 AC Fail 0, 0, 0, 0 (Not Used)
LOCATION 172 - 175 Low Battery 0, 0, 0, 0 (Not Used)
LOCATION 176 - 179 Sensor Watch 0, 0, 0, 0 (Not Used)
LOCATION 180 - 181 Open/Close Reports 0, 0 (Not Used)
LOCATION 182 – 185 Test Report Time 0, 0, 0, 9 (Not Used)
Table 5: Command 965 Defaults
As you can see from the table above, all reporting other than zone alarms have been disabled.
The handshake tone has been set for 1400 Hz tone acknowledgment and the Subscriber ID
Number has been set for one identification beep. The zone reporting has been set so that any
zone that triggers an alarm condition will only report when the alarm occurs, the zone restore
report will not report as there is no separate indications for zone alarm reports and zone alarm
restore reports.
Electronics Design and Manufacturing Pty Limited
ISSUE123.DOC